ABB NPOW-62C电源电路板
1.产 品 资 料 介 绍：
中文资料：
ABB NPOW-62C数据加电源指定每次加电后要使用（或加载/复制到RAM中）的参考数据的位置/源。选择：始终RAM，始终闪存，条件闪存。默认值：始终RAM
ABB NPOW-62C（运行/停止开关）启用或禁用RUN/STOP开关的物理操作。选择：已启用：使您能够使用PLC上的物理开关将PLC切换到STOP模式或从STOP模式切换到RUN模式，并清除非致命故障。禁用：禁用PLC上的物理运行/停止开关。ABB NPOW-62C
ABB NPOW-62C默认值：已启用。注：如果COM1和COM2被配置为除RTU Slave或SNP Slave之外的任何协议，则在没有首先确保有方法停止CPU或通过以太网接口等其他设备控制CPU的情况下，不应禁用RUN/STOP开关。如果CPU可以设置为STOP Mode（停止模式），ABB NPOW-62C它将把协议从串行I/O切换到STOP Mode（停机模式）协议（默认为RTU Slave）。有关停止模式设置的详细信息，请参阅COM1和COM2参数。
英文资料：
ABB NPOW-62CData Power-up Source Specifies the location/source of the reference data that is to be used (or loaded/copied into RAM) after each power up. Choices: Always RAM, Always Flash, Conditional Flash. Default: Always RAMABB NPOW-62C
ABB NPOW-62C Switch Enables or disables the physical operation of the RUN/STOP Switch. Choices: Enabled: Enables you to use the physical switch on the PLC to switch the PLC into STOP Mode or from STOP Mode into RUN Mode and clear non-fatal faults. Disabled: Disables the physical RUN/STOP Switch on the PLC.
ABB NPOW-62CDefault: Enabled. Note: If COM1 and COM2 are configured for any protocol other than RTU Slave or SNP Slave, the RUN/STOP Switch should not be disabled without first must making sure that there is a way to stop the CPU, or take control of the CPU through another device such as an Ethernet interface. If the CPU can be set to STOP Mode, it will switch the protocol from Serial I/O to the STOP Mode protocol (default is RTU Slave). For details on STOP Mode settings, refer to COM1 and COM2 Parameters.
2.产 品 展 示
3.主 营 品 牌
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
