ABB YPQ201A YT204001-KA输入输出模块
1.产 品 详 情 资 料：
主要功能•提供一个S100 I/O端口（位于TP856基板上的36针中心线微型带状连接器）。•简单的DIN导轨安装•CI856可处理位于最多五个I/O机架中的S100 I/O单元的I/O扫描和更新。最小循环扫描/更新间隔为0.2ms，但这将取决于I/O类型和I/O点的数量。•安装在机组底座中的预设两个字母的阿尔法代码锁定装置可防止安装不兼容的组件。•支持热插拔。说明CI856/TP856将S100 I/O连接到AC 800M。TP856基板有一个36针中心线微型带状连接器，用于连接S100 I/O机架。底板有一个代码锁，见第75页表4，可防止在TP856底板上安装不正确类型的装置。CI856扩展单元包含CEX总线逻辑、S100 I/O总线逻辑、CPU和DC/DC转换器，该转换器通过CEX总线从+24 V电源提供适当的电压。检测到F（故障）/红色单元错误。由CI856软件控制。在控制器重置期间由硬件设置。成功启动后由CI856软件清除。R（un）/绿色运行。由控制软件控制。在控制器重置过程中被硬件清除。在S100 I/O访问超时时，TO/黄色闪烁。
Key Features • Provides one S100 I/O port, (a 36 pin centerline miniature ribbon connector located on the TP856 Baseplate). • Simple DIN-rail mounting • The CI856 handles I/O scanning and updating of S100 I/O units located in up to five I/O racks. The minimum cyclic scan/update interval is 0.2ms, though this will depend on I/O type and number of I/O points. • Pre-set, two-letter Alpha code locking device installed in unit base prevents mounting of incompatible components. • Supports Hot swap. Description The CI856/TP856 connects S100 I/O to AC 800M.The TP856 Baseplate has one 36-pin centerline miniature ribbon connector for connecting S100 I/O racks. The baseplate has a code lock, see Table 4 on page 75, that prevents installation of an incorrect type of unit onto the TP856 Baseplate. The CI856 expansion unit contains the CEX-Bus logic, S100 I/O-bus logics, CPU and a DC/DC converter that supplies appropriate voltages from the +24 V supply, via the CEX-Bus.F(ault) /Red Unit error detected. Controlled by CI856 Software. Set by the Hardware during controller Reset. Cleared by the CI856 Software after successful startup. R(un) /Green Operating. Controlled by the Control Software. Cleared by the Hardware during controller Reset. TO /Yellow Flashes at S100 I/O access time-outs.
2.产 品 展 示
3.公 司 优 势 主 营 产 品
4.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
