HITACHI 2-822037-A控制脉冲卡件
1.产 品 详 情 资 料：
在装置中检测到F（故障）/红色错误。由控制软件控制。在控制器复位期间由硬件设置并清除。R（un）/绿色运行。由控制软件控制。在控制器复位期间被硬件清除。如果传输到COM1端口，Tx1/黄色闪烁。如果从COM1端口接收，Rx1/黄色闪烁。从COM2端口传输，Tx2/黄色闪烁。若从COM2接口接收，Rx2/黄色闪烁，表81。CI853–RS-232C通信接口规范项目描述类型带调制解调器信号的双未隔离RS-232C端口。通道数量2通道协议由软件、应用程序和许可证决定。适用于Modbus、西门子3964R、COMLI和自定义设计的协议。有关详细信息，请参阅CB。通信速度可在75到19200波特之间选择。75、110、134.5、150、300、600、1200、1800、2000、2400、9600、19200波特。协议特定限制适用。alvanic isolation Unisolated Status indicators正常运行：绿色。异常故障：红色。四个交通指示器-Rx和Tx-由交通速度控制：闪烁黄色。连接器TP853上的两个RJ45连接器。电流消耗（来自CEX总线24 V DC）100 mA典型（最大150 mA）功率耗散2.4 W典型保护等级IP20，符合EN60529和IEC 529。
F(ault) /Red Error detected in the unit. Controlled by the Control Software. Set and cleared by the Hardware during Reset of the controller. R(un) /Green Operating. Controlled by the Control Software. Cleared by the Hardware during Reset of the controller. Tx1 /Yellow Flashes if transmission to the COM1 port. Rx1 /Yellow Flashes if receiving from the COM1 port. Tx2 /Yellow Flashes if transmission from the COM2 port. Rx2 /Yellow Flashes if receiving from the COM2 port. Table 81. CI853 – RS-232C Communication Interface Specifications Item Description Type Double unisolated RS-232C ports with modem signals. Number of channels 2 channels Protocol Determined by software, application and licenses. Intended for Modbus, Siemens 3964R, COMLI and custom designed protocols. Please refer to CB for details. Communication speed Selectable in steps from 75 to 19200 baud. 75, 110, 134.5, 150, 300, 600, 1200, 1800, 2000, 2400, 9600, 19200 baud. Protocol specific restrictions apply.alvanic isolation Unisolated Status indicators Running normally: Green. Exceptional fault: Red. Four traffic indictors - Rx and Tx - controlled by traffic pace: Flashing yellow. Connector Two RJ45 connectors on TP853. Current consumption (from CEX-Bus 24 V DC) 100 mA typical (150 mA max.) Power Dissipation 2.4 W typical Protection Rating IP20 according to EN60529, IEC 529.
2.产 品 展 示
3.公 司 优 势 主 营 产 品
4.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
