ABB 88UM01A GJR2329800R0100输入输出模块
1.产 品 详 情 资 料：
R（un）和F（ault）LED均熄灭可能原因1：ABB 88UM01A GJR2329800R0100模块连接到控制器，但配置没有下载到该位置的控制器。纠正措施1：确保在硬件树（控制生成器中）中为该位置配置了ABB 88UM01A GJR2329800R0100模块，并将配置下载到控制器。可能原因2：ABB 88UM01A GJR2329800R0100模块刚刚通电，或者正在配置和下载。纠正措施2：为模块初始化留出时间。纠正措施3：如果在执行纠正措施1和2后指示仍然存在，则建议采取以下纠正措施之一：•拆除ABB 88UM01A GJR2329800R0100模块并将其插入CEX总线，并留出时间进行初始化。•如果此ABB 88UM01A GJR2329800R0100是CEX总线上的唯一模块，或者如果CEX总线已经包含其他通信模块，并且这些模块上的所有LED都熄灭，则建议采取以下纠正措施之一：-从PM8xx处理器单元启动复位信号（INIT）。-检查PM8xx处理器单元内的CEX总线保险丝纠正措施4：如果在执行纠正措施1至3后指示仍然存在，则更换ABB 88UM01A GJR2329800R0100模块。
Both R(un) and F(ault) LED's are OFF Possible Cause 1: The ABB 88UM01A GJR2329800R0100 module is connected to the controller, but the configuration is not downloaded to the controller for that position. Corrective Action 1: Ensure that the ABB 88UM01A GJR2329800R0100 module is configured in the Hardware Tree (in the Control Builder) for that position, and that the configuration is downloaded to controller. Possible Cause 2: The ABB 88UM01A GJR2329800R0100 module is just powered up or it is being configured and downloaded. Corrective Action 2: Allow time for the module to initialize. Corrective Action 3: If the indication persists after performing the corrective actions 1 and 2, then one of the following corrective actions is recommended: • Remove and insert the ABB 88UM01A GJR2329800R0100 module to the CEX-Bus and allow time for it to initialize. • If this ABB 88UM01A GJR2329800R0100 is the only module on the CEX-Bus, or if the CEX-Bus already contains other communication modules and all the LED's on those modules are OFF, then one of the following corrective actions is recommended: - Initiate a reset signal (INIT) from the PM8xx processor unit. - Check the CEX-Bus fuse inside the PM8xx processor Unit Corrective Action 4: If the indication still persists after performing the corrective actions 1 to 3, replace the ABB 88UM01A GJR2329800R0100 module.
2.产 品 展 示
3.公 司 优 势 主 营 产 品
4.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
