NI PXI-5600变频器
1.产 品 介 绍
品牌：NI
型号说明：NI PXI-5600变频器
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
将PROFIBUS DP电缆连接到基板上的PROFIBUS A或PROFIBUS B连接器之一。为了支持线路冗余，将另一根PROFIBUS DP电缆连接到另一个触点。5.如果NI PXI-5600位于PROFIBUS DP电缆的末端，则打开总线终端。否则，保持总线终端关闭。以下适用于NI PXI-5600：6。如果CI854A安装在冗余配置中，将PROFIBUS DP电缆连接到主模块和备用模块。如第117页图39所示。将位于线路末端的主模块或备用模块上的接口终端打开。PROFIBUS DP连接PROFIBUS DP电缆通过位于TP854上的9针D型母连接器连接。现场总线和推荐的认证现场总线设备和组件的安装，请参阅现场总线文件和附录C，推荐组件。PROFIBUS DP必须与屏蔽双绞线连接。NI PXI-5600
Connect the PROFIBUS DP cable to one of the connectors PROFIBUS A or PROFIBUS B on the baseplate. For support of Line Redundancy connect a second PROFIBUS DP cable to the other contact. 5. If the NI PXI-5600 is at the end of the PROFIBUS DP cable, switch the bus termination ON. Otherwise leave the bus termination switched OFF. The following applies for CI854A: 6. If the NI PXI-5600 is installed in a redundant configuration connect the PROFIBUS DP cable to primary and backup module. Do it like described in Figure 39 on page 117. Switch the termination ON for the interface on primary or backup module that is at the end of the line.PROFIBUS DP Connection The PROFIBUS DP cable is connected via the 9-pin female D-type connector located on TP854.For installation of the fieldbus and recommended certified fieldbus devices and components, see fieldbus documentation and Appendix C, Recommended Components. The PROFIBUS DP must be connected with shielded twisted pair cables.
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
