Juniper FEB-M10i-M7i-E-S-D网络板
1.产 品 介 绍
品牌：Juniper
型号说明：Juniper FEB-M10i-M7i-E-S-D网络板
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
Juniper FEB-M10i-M7i-E-S-DGCSR寄存器在VMEbus短I/O空间中访问。每个通用寄存器有两个字节宽，出现在偶数地址。通用寄存器编号0与GCSR寄存器的起始位置偏移$8（本地总线）或$4（VMEbus）。GCSR的本地总线基址为$FFF40100。GCSR的VMEbus基址取决于MVME162FX控制器的本地控制和状态寄存器（LCSR）中编程的组选择值和板选择值。通过以下方式读取GCSR通用寄存器来形成执行地址：GPCSR0用作地址GPCSR1的高位16位，GPCSR1用作地址诊断设施的低位16位。Juniper FEB-M10i-M7i-E-S-D要使用诊断，请将目录切换到诊断目录。如果您位于调试器目录中，可以使用调试器命令“切换目录（SD）”切换到诊断目录。出现诊断提示（“162 Diag>”）。Juniper FEB-M10i-M7i-E-S-D
The GCSR registers are accessed in the VMEbus short I/O space. Each general purpose register is two bytes wide, occurring at an even address. The general purpose register number 0 is at an offset of $8 (local bus) or $4 (VMEbus) from the start of the GCSR registers. Juniper FEB-M10i-M7i-E-S-DThe local bus base address for the GCSR is $FFF40100. The VMEbus base address for the GCSR depends on the group select value and the board select value programmed in the Local Control and Status Registers (LCSR) of the MVME162FX controller. The execution address is formed by reading the GCSR general purpose registers in the following manner:GPCSR0 used as the upper 16 bits of the address GPCSR1 used as the lower 16 bits of the address Diagnostic Facilities The 162Bug package includes a set of hardware diagnostics for testing and troubleshooting the MVME162FX controller. To use the diagnostics, switch directories to the diagnostic directory. If you are in the debugger directory, you can switch to the diagnostic directory with the debugger command Switch Directories (SD). The diagnostic prompt ("162-Diag>") appears.Juniper FEB-M10i-M7i-E-S-D
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
