REXROTH DKC03.3-100-7-FW伺服驱动器
1.产 品 介 绍
品牌：REXROTH
型号说明：REXROTH DKC03.3-100-7-FW伺服驱动器
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
REXROTH DKC03.3-100-7-FW当IP DMA控制器是本地总线主控器时，报头J26定义了窥探控制总线的状态。出厂配置中有两个跳线，用于禁止窥探。验证此设置是否适合您的应用程序。9.有关REXROTH DKC03.3-100-7-FW安装的详细信息，请参阅特定机箱或系统的安装程序。10.将用作162Bug系统控制台的终端连接到REXROTH DKC03.3-100-7-FW控制器前面板上串行端口1处的默认调试EIA-232-D端口。有关其他连接选项，请参阅第2章。按如下方式设置终端：–每个字符八位–每个字符一个停止位–禁用奇偶校验（无奇偶校验）–波特率9600波特（MVME162FX控制器端口通电时的默认波特率）通电后，如果需要，可以使用162Bug调试器的端口格式（PF）命令重新配置调试端口的波特率。REXROTH DKC03.3-100-7-FW
Header J26 defines the state of the snoop control bus when an IP DMA controller is local bus master. The factory configuration has both jumpers in place for snoop inhibition. Verify that this setting is appropriate for your application. 9. Refer to the setup procedure for your particular chassis or system for details concerning theREXROTH DKC03.3-100-7-FWinstallation. 10. Connect the terminal that is to be used as the 162Bug system console to the default debug EIA-232-D port at serial port 1 on the front panel of the REXROTH DKC03.3-100-7-FW controller. Refer to Chapter 2 for other connection options. Set up the terminal as follows: – eight bits per character – one stop bit per character – parity disabled (no parity) – baud rate 9600 baud (default baud rate of MVME162FX controller ports at power-up) After power-up, you can reconfigure the baud rate of the debug port if necessary by using the Port Format (PF) command of the 162Bug debugger.REXROTH DKC03.3-100-7-FW
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
