REXROTH MAC090C-0-GD-4-C/110-A-1伺服电机
1.产 品 介 绍
品牌：REXROTH
型号说明：REXROTH MAC090C-0-GD-4-C/110-A-1伺服电机
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
REXROTH MAC090C-0-GD-4-C/110-A-1检查收割台J21上的跳线安装尺寸是否正确。连接J21上27C080设备的针脚1和2，或27C040设备的针脚2和3。出厂默认值为2和3。拆除J22引脚9和10上的跳线。注意：如果您希望在后续会话中使用闪存而不是PROM执行调试器，则需要在通电后初始化闪存，如步骤12所述。6.标头J24上的跳线将IP总线时钟配置为8MHz（在MVME162-4xx和-5xx板上）或32MHzREXROTH MAC090C-0-GD-4-C/110-A-1（仅限MVME162-5xx板）。工厂配置在J24引脚1和2之间安装一条跳线，用于8MHz时钟。验证此设置是否适合您的应用程序。7.标头J25上的跳线启用/禁用MVME162FX上的IP总线选通功能。工厂配置在J25引脚1和2之间放置跳线，以将Strobe*信号连接到IP2芯片。验证应用程序中是否连接了选通线。REXROTH MAC090C-0-GD-4-C/110-A-1
Check the jumper installation on header J21 for correct size. Connect pins 1 and 2 on J21 for 27C080 devices, or pins 2 and 3 for 27C040 devices. The factory default is 2 and 3.REXROTH MAC090C-0-GD-4-C/110-A-1Remove the jumper on J22 pins 9 and 10.Note If you wish to execute the debugger out of flash memory rather than from PROM in subsequent sessions, it will be necessary to initialize the flash memory after power-up as described in Step 12. 6. The jumper on header J24 configures the IP bus clock for either 8MHz (on both MVME162-4xx and -5xx boards) or 32MHz (on MVME162-5xx boards only). The factory configuration installs a jumper between J24 pins 1 and 2 for an 8MHz clock. Verify that this setting is appropriate for your application. 7. The jumper on header J25 enables/disables the IP bus strobe function on the MVME162FX. The factory configuration puts a jumper between J25 pins 1 and 2 to connect the Strobe∗ signal to the IP2 chip. Verify that the strobe line should be connected in your application.REXROTH MAC090C-0-GD-4-C/110-A-1
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
