REXROTH MHD041B-144-PG0-UN伺服电机
1.产 品 介 绍
品牌：REXROTH
型号说明：REXROTH MHD041B-144-PG0-UN伺服电机
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
REXROTH MHD041B-144-PG0-UN如果随后希望从闪存运行调试器，则必须首先使用PFLASH命令初始化闪存，然后重新配置J22。有关更多信息，请参阅下面的步骤5。安装和启动请按照下面的步骤使用REXROTH MHD041B-144-PG0-UN控制器操作162Bug。162Bug出厂时安装在REXROTH MHD041B-144-PG0-UN的闪存中，没有VMEbus的情况除外！小心在通电时插入或移除模块可能会损坏模块组件。1.关闭所有设备电源。请参阅第2章“硬件准备”一节，并根据特定应用的需要安装/拆除集管上的跳线。收割台J22上的跳线影响162Bug操作，如下所示。默认情况下，所有八个跳线都安装在引脚1-2、3-4、5-6、7-8、9-10、11-12、13-14和15-16之间。没有VMEbus接口的型号在引脚9-10之间没有跳线。REXROTH MHD041B-144-PG0-UN
If you subsequently wish to run the debugger from Flash memory, you must first initialize Flash memory with the PFLASH command, then reconfigure J22. Refer to Step 5 below for additional information.Installation and Startup Follow the steps below to operate 162Bug with the MVME162FX controller. 162Bug is factory-installed in the flash memory of theREXROTH MHD041B-144-PG0-UN, except in the no-VMEbus case. ! Caution Inserting or removing modules while power is applied could damage module components. 1. Turn all equipment power OFF. Refer to the Hardware Preparation section in Chapter 2 and install/remove jumpers on headers as required for your particular application. Jumpers on header J22 affect 162Bug operation as listed below. The default condition is with all eight jumpers installed, between pins 1- 2, 3-4, 5-6, 7-8, 9-10, 11-12, 13-14, and 15-16. Models with no VMEbus interface have no jumper between pins 9-10.REXROTH MHD041B-144-PG0-UN
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
