REXROTH DKC113-040-7-FW伺服驱动器
1.产 品 介 绍
品牌：REXROTH
型号说明：REXROTH DKC113-040-7-FW伺服驱动器
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
REXROTH DKC113-040-7-FW嵌入式控制器通过位于P2适配器板或LCP2适配器板上的1A保险丝（F1）提供SCSI终端电源。如果保险丝熔断，SCSI设备可能工作不稳定或根本不工作。当P2适配器板与REXROTH DKC113-040-7-FW一起使用并且SCSI总线连接到MVME712M时，当SCSI终端电源可用时，REXROTH DKC113-040-7-FW前面板上的绿色DS2 LED亮起。如果绿色DS2 LED在SCSI总线操作期间闪烁，请检查P2适配器板保险丝F1。以下页面中的图2-3、2-4、2-5和2-6说明了端口A和B可用的各种串行配置中的信号关系和信号连接。M68000固件概述基于M68000的（68K）系列板级和系统级产品的固件具有通用谱系，源于当前在所有基于Motorola M68000的CPU模块上使用的调试器固件。M68000固件系列提供了高度的功能性和用户友好性，同时强调了可移植性和易维护性。
TheREXROTH DKC113-040-7-FW Embedded Controller provides SCSI terminator power through a 1A fuse (F1) located on the P2 Adapter Board or LCP2 Adapter Board. If the fuse is blown, the SCSI device(s) may function erratically or not at all. When the P2 Adapter Board is used with an MVME712M and the SCSI bus is connected to the MVME712M, the green DS2 LED on theREXROTH DKC113-040-7-FWfront panel illuminates when SCSI terminator power is available. If the green DS2 LED flickers during SCSI bus operation, check P2 Adapter Board fuse F1. Figures 2-3, 2-4, 2-5, and 2-6 on the following pages illustrate the signal relationships and signal connections in the various serial configurations available for ports A and B.Overview of M68000 Firmware The firmware for the M68000-based (68K) series of board and system level products has a common genealogy, deriving from the debugger firmware currently used on all Motorola M68000-based CPU modules. The M68000 firmware family provides a high degree of functionality and user friendliness, and yet stresses portability and ease of maintenance.REXROTH DKC113-040-7-FW
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
