REXROTH HMS01.1N-W0020-A-07-NNNN驱动逆变器
1.产 品 介 绍
品牌：REXROTH
型号说明：REXROTH HMS01.1N-W0020-A-07-NNNN驱动逆变器
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
REXROTH HMS01.1N-W0020-A-07-NNNN如果：–中央模块或两个中央模块发生故障或退出–发生故障时系统变为STOP模式–通过编程器单元将系统设置为STOP模式，则输出将被冻结。如果发生故障，模块的输出可能具有H或L信号。这对于可测试和不可测试的输出模块同样有效。REXROTH HMS01.1N-W0020-A-07-NNNN仅可通过拔出模块、电缆连接器或中断模块电源电压来关闭。插入和拔出模块HIMA PES H41q、H51q的模块可在不影响系统的情况下拔出和插入。螺丝刀或振动不能使模块倾斜。I/O模块退出：1。拆下模块的固定螺钉。2.取出模块和电缆插头。3.拧下电缆插头。插入：1。插入并固定不带电缆插头的模块。2.插入电缆插头并用螺钉固定。3.对于可测试模块，按下中央模块上的ACK键。REXROTH HMS01.1N-W0020-A-07-NNNN
The outputs will be frozen if: – the central module or both central modules are failed or withdrawed – the system changes to the STOP mode in case of a fault – the system is set to the STOP mode by means of the programmer unit. The outputs of the module may have H- or L-signal in the case of a fault. This is also valid for testable as for non-testable output modules. Switching off is only possible by withdrawing the module, the cable connector or by interrupting the modules supply voltage.To Insert and to Withdraw Modules The modules of the HIMA PES REXROTH HMS01.1N-W0020-A-07-NNNN1q may be withdrawed and inserted without disadvantageous influence for the system. The modules may not be cant by a screwdriver or by vibrations.I/O modules Withdraw: 1. Remove fixing screws of the module. 2. Withdraw the module together with the cable plug. 3. Screw off the cable plug. Insert: 1. Insert and fix the module without cable plug. 2. Plug in the cable plug and fix it by the screws. 3. With testable modules, press the ACK key on the central module.REXROTH HMS01.1N-W0020-A-07-NNNN
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.关 于 相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
