REXROTH MSK050C-0600-NN-M1-UP1-NSNN伺服电机
1.产 品 介 绍
品牌：REXROTH
型号说明：REXROTH MSK050C-0600-NN-M1-UP1-NSNN伺服电机
优势：供应进口原装正品，专业停产配件。
公司主营特点：主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。
2.产 品 详 情 资 料：
REXROTH MSK050C-0600-NN-M1-UP1-NSNN输出模块的一般功能所有输出模块都具有以下特殊功能：–为了提高可用性，安全相关输出模块的输出可以在没有外部二极管的情况下并联切换–当输出模块上切断电源电压L-时，不会出现输出电压，因此，无需将L作为环形馈线布线–电感负载的连接可以在不使用线圈上的二极管的情况下完成。但是，建议将二极管直接连接到感应负载上，以避免噪声电压。REXROTH MSK050C-0600-NN-M1-UP1-NSNN–单独控制发出输出状态信号的LED–电缆插头的设计可实现执行器的两极连接。与输出模块的两极电源一起，将简化接地故障检测–如果输出模块有缺陷，操作无时间限制。系统电压24 V DC为HIMA系统供电，有两种不同的电势：正极也可用于电源电压和控制电压。为了实现单相电源连接的有效值，需要具有桥式整流和平滑的电源装置或稳定的电源装置。REXROTH MSK050C-0600-NN-M1-UP1-NSNN
General features of the Output Modules All output modules have the following special features: – To increase the availability the outputs of the safety related output modules can be switched in parallel without external diodes – No output voltage occurs when the supply voltage L- should be cut on the output module, so it is not necessary to wire the L- as a ring feeder – The connection of inductive loads can be done without using diodes at the coil. REXROTH MSK050C-0600-NN-M1-UP1-NSNNHowever it is recommended to connect a diode directly at the inductive load avoiding noise voltages. – The LED signalling the output status is controlled separately – The design of the cable plugs enables the two pole connection of the actuators. Together with a two pole supply of the output module an earth fault detection will be simplified – No time limit for operation in case of a defective output module.System Voltage 24 V DC For supplying a HIMA system there are two different potentials available:The positive pole is usable also for power voltage and control voltage. To achieve the valid values for the connection of single phase mains supplies, power supply units with bridge rectification and smoothing are required or stabilized power supply units.REXROTH MSK050C-0600-NN-M1-UP1-NSNN
3.产 品 展 示
4.公 司 优 势 主 营 产 品
5.关 于 相 关 产 品 展 示
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
