HONEYWELL FC-SDO-0824数字输出
1.产 品 介 绍
品牌：HONEYWELL
型号：HONEYWELL FC-SDO-0824
产品说明：数字输出
优势：供应进口原装正品，专业停产配件。
2.产 品 详 情 资 料：
HONEYWELL FC-SDO-0824电缆选择和交叉参考三条电缆可用于连接模块面板连接器和接线盒。这些电缆的唯一区别是它们的长度。这些电缆在模块端部具有直角连接器，以尽量减少模块前面所需的空间。这三条电缆取代了三条带有直接头的过时电缆。使用下表为16点模块选择正确的电缆I/O面板I/O面板（目录号IC693ACC334）具有24针连接器，通过0.5、1或2米电缆连接到适用的接线板。该面板取代了所列模块上的标准接线板。I/O面板安装步骤1：在DIN导轨上安装接线板组件将接线板放置在DIN导轨的所需位置上并卡入到位。HONEYWELL FC-SDO-08241.打开塑料接线板向上推顶杆以释放接线板。朝着你的方向抓住拉片，直到触点与模块外壳分离，挂钩脱离，以便完全取下。HONEYWELL FC-SDO-0824
Cable Selection and Cross-Reference Three cables are available for connecting between the module’s faceplate connector and the terminal block.HONEYWELL FC-SDO-0824The only difference in these cables is their length. These cables have right-angle connectors on the module end to minimize the space required in front of the modules. These three cables replace three obsolete cables that had straight connectors. Use the following table to select the correct cable I/O Face Plate for 16-Point Modules The I/O Face Plate (catalog number IC693ACC334) has a 24-pin connector, which provides the connection to the applicable terminal block through a 0.5,HONEYWELL FC-SDO-0824 1, or 2 meter cable. This face plate replaces the standard terminal board on the listed modules.I/O Face Plate Installation Step 1: Install terminal block assembly on DIN rail Place the terminal block over the desired location on the DIN rail and snap into place.1.Open the plastic terminal board Push up on the jacking lever to release the terminal block. Grasp pull-tab towards you until contacts separated from module housing and hook disengaged for full removal.HONEYWELL FC-SDO-0824
3.产 品 展 示
4.公 司 优 势
5.关 于 我 们
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
