NI PXIE-6738 PXI模拟输出模块
1.产 品 介 绍
品牌：NI
型号：NI PXIE-6738
产品说明：PXI模拟输出模块
优势：供应进口原装正品，专业停产配件。
2.产 品 详 情 资 料：
NI PXIE-6738 步骤1：计算模块损耗的基本方法请注意，此步骤不适用于第2步中介绍的电源模块。该计算所需的值见第12章“荷载要求”表。在这些计算中使用以下电功率公式假设这些模块的所有输入功率最终都作为热量消散。程序如下：Ŷ在“硬件组件的负载要求”表（第12章）中查找模块，NI PXIE-6738 并获得列出的三个电源电压中每一个的电流值。电压打印在每列的开头。所有模块都使用5VDC电源，相对较少的模块也使用两个24VDC电源中的一个或两个。Ŷ对于给定模块，通过将电流值（以安培为单位）乘以该列的电压，计算表中包含电流值的每列的功耗。对于使用多个电压的模块，将计算的功率值相加，得出模块的总功率。NI PXIE-6738
Step 1: Basic Method to Calculate Module Dissipation Note that this step does not apply to Power Supply Modules, which are covered in Step 2. The values needed for this calculation are found in the “Load Requirements” table in Chapter 12. Use the following electrical power formula in these calculations Assume that all input power to these modules is eventually dissipated as heat.NI PXIE-6738 The procedure is: Ŷ Look up the module in the NI PXIE-6738 “Load Requirements for Hardware Components” table (Chapter 12) and obtain the current values for each of the three power supply voltages listed. The voltage is printed at the head of each column. All modules use the 5VDC supply, and a relatively few modules also use one or both of the two 24VDC supplies. Ŷ For a given module, calculate the power dissipation for each column in the table that contains a current value by multiplying the current value (in Amps) times the voltage for that column. For modules using more than one voltage, add the calculated power values to arrive at the total for the module.NI PXIE-6738
3.产 品 展 示
4.公 司 优 势
5.关 于 我 们
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
