HONEYWELL RTU2020控制器
1.产 品 介 绍
品牌：HONEYWELL
型号：HONEYWELL RTU2020控制器
产品说明：模块卡件
特点：模块/卡件，控制器，触摸屏，伺服驱动器
优势：供应进口原装正品，专业停产配件。
快递方式：国内顺丰、德邦、京东快递包邮，按照实际报价货期发货
2.产 品 详 情 资 料：
HONEYWELL RTU2020控制器制作100%屏蔽电缆使用以下步骤制作100%屏蔽的电缆：1。剥去定制电缆上约5/8英寸的绝缘层，露出屏蔽层。2.从直接插入旧版本远程基板HONEYWELL RTU2020的任何连接器上取下公引脚1。3.将开口环套圈置于电缆绝缘层上（图10-17）。4.在电缆绝缘层和套圈的顶部折叠屏蔽层。5.将金属罩的套环放在折叠护罩的顶部，并牢牢夹住罩。6.测试电缆在两个连接器外壳之间的导通性。在外壳之间连接欧姆表，HONEYWELL RTU2020并在两端弯曲电缆。如果金属化连接器罩未与电缆屏蔽层的两端正确接触，欧姆表上的连接将显示间歇性连续性。7.将金属带帽电缆插入远程底板扩展端口连接器或GE Fanuc WYE电缆，并牢固拧紧两个螺钉。安装和拧紧螺钉将使屏蔽与远程底板框架接地电气连接，远程底板框架应按照“安装”章节“底板安全接地”中的指示与接地连接
Making a 100% Shielded Cable Use the following steps to build a 100% shielded cable: 1. Strip approximately 5/8 inch of insulation from your custom cable to expose the shield. 2. Remove the male Pin 1 from any connector plugging directly into an older version remote baseplate HONEYWELL RTU20203. Put split-ring ferrule over cable insulation (Figure 10-17). 4. Fold the shield back over top of the cable insulation and ferrule. 5. Place the collar of the metal hood over top of the folded shield and securely clamp the hood. 6. Test your cable for continuity between both connector shells. HONEYWELL RTU2020Connect an ohmmeter between the shells and flex the cable at both ends. If the metallized connector hood is not making proper contact with the cable shield at either end, the connection will show intermittent continuity on the ohmmeter. 7. Plug the metal hooded cable onto a remote baseplate expansion port connector or into a GE Fanuc WYE cable and securely tighten the two screws. Installing and tightening the screws will electrically connect the shield to the remote baseplate frame ground, which should in turn should be connected to earth ground as instructed in the “Installation” chapter, under the heading “Baseplate Safety Grounding.”HONEYWELL RTU2020
3.产 品 展 示
4.关 于 我 们
本篇文章出自瑞昌明盛自动化设备有限公司官网，转载请附上此链接:http://www.jiangxidcs.com
