ABB IMMFP03B多功能处理器内存模块
品牌：ABB
型号：ABB IMMFP03B
产品说明：多功能处理器内存模块
ABB IMMFP03B多功能处理器内存模块中文资料：
ABB IMMFP03B多功能处理器内存模块使用这些适配器支架时，请务必遵循第2章中的接地说明。PLC未正确接地可能导致操作不当、设备损坏和人员受伤。IC693ACC308前安装适配器支架。用于将基板安装到19“机架。通过将适配器支架顶部和底部的卡舌插入塑料基板盖顶部和底部对应的插槽中来安装适配器支架。注意：虽然下图显示了塑料基板盖已拆下，但这仅用于说明目的。无需拆下盖即可安装支架。ABB IMMFP03B支架就位后，插入并将两个螺钉（包括在支架中）穿过底板孔的背面拧入支架IC693ACC313嵌入式安装适配器支架的螺纹孔中。用于在19“机架内凹进安装底板。底板使用四个8-32（4mm）螺钉、螺母、锁紧垫圈和平垫圈安装在适配器支架的后面板上。适配器支架使用适用的硬件（建议使用锁紧垫圈）通过其四个槽孔螺栓固定到19”机架的表面。ABB IMMFP03B
英文资料
Be sure to follow grounding instructions in Chapter 2 when using these adapter brackets. Failure to properly ground the PLC can result in improper operation, damage to equipment, and injury to personnel.IC693ACC308 Front Mount Adapter Bracket. Used to mount a baseplate to the front face of a 19" rack. Install the adapter bracket by inserting the tabs at the top and bottom of the adapter bracket into the corresponding slots at the top and bottom of the plastic baseplate cover. NOTE: Although the figure below shows the plastic baseplate cover removed, this is for illustration purposes only. It is not necessary to remove the cover to install the bracket. With the bracket in place, insert and tighten the two screws (included with the bracket) through the back of the baseplate holes into the threaded holes in the bracket IC693ACC313 Recessed Mount Adapter Bracket. Used to recess mount a baseplate inside a 19" rack. A baseplate mounts on the rear panel of this adapter bracket using four 8-32 (4mm) screws, nuts, lock washers, and flat washers. The Adapter Bracket bolts through its four slotted holes to the face of the 19" rack using applicable hardware (lock washers recommended).ABB IMMFP03B
每 日 展 示
公 司 主 营 优 势
应 用 行 业
