ABB FI810F 3BDH000030R1总线模块
ABB FI810F 3BDH000030R1总线模块中文资料：
ABB FI810F 3BDH000030R1总线模块这些电缆的一端有一个24针连接器，另一端有带导线标记的剥线镀锡导线。（2） 使用一对双连接器电缆将模块连接到接线板快速连接（TBQC）接线板（IC693ACC377）。详见附录H。（3） 制作自己的自定义电缆。说明见第10章IC693CBL327/328数据表。输入/输出模块端子板90-30系列PLC输入/输出端子板的连接有10个或20个螺丝端子，可接受两个AWG#22（0.36 mm2）至两个AWG#16（1.3 mm2）或一个AWG#14（2.1 mm2）90°C（194°F）ABB FI810F 3BDH000030R1铜线。每个端子都可以接受实心线或绞合线，但进入任何给定端子的导线应为相同类型（实心线或双绞合线），以确保良好连接。电线从端子板空腔底部布线到端子。I/O端子板连接螺钉的建议扭矩为9.6 in-lbs至11.5 in-lbs（1.1–1.3牛顿米）。ABB FI810F 3BDH000030R1
英文资料
These cables have a 24-pin connector on one end, and stripped, tinned leads with wire markers on the other end. (2) Use a pair of dual-connector cables to connect the module to a Terminal Block Quick Connect (TBQC) terminal block (IC693ACC377). See Appendix H for details. (3) Make your own custom cables. Instructions are found in the IC693CBL327/328 data sheet in Chapter 10. Connections to I/O Module Terminal Boards Series 90-30 PLC I/O terminal boards have either 10 or 20 screw terminals that will accept from two AWG #22 (0.36 mm2 ) to two AWG #16 (1.3 mm2 ), or one AWG #14 (2.1 mm2 ) copper 90°C (194°F) wire(s). Each terminal can accept solid or stranded wires, but the wires into any given terminal should be the same type (both solid or both stranded) to ensure a good connection. Wires are routed to and from the terminals out of the bottom of the terminal board cavity. The suggested torque for the I/O terminal board connection screws is from 9.6 in-lbs to 11.5 in-lbs (1.1–1.3 Newton-meters).ABB FI810F 3BDH000030R1
每 日 展 示
公 司 主 营 优 势
应 用 行 业
