ABB IIMLM01输入输出卡件
ABB IIMLM01输入输出卡件中文资料：
ABB IIMLM01输入输出卡件安装模块的端子板注意：模块IC693MDL730F（及更高版本）和IC693MDL 731F（及更新版本）具有配备固定螺钉的特殊端子板。有关安装和拆卸说明，请参阅本章后面的“使用固定螺钉安装和拆卸端子板”一节。安装端子板（带圆圈的数字参见下图）：ABB IIMLM01勾住枢轴钩➀, 将位于端子板底部的连接器连接到模块上的下部插槽。Ŷ将端子板推向模块➁ 直到它卡入到位。Ŷ打开端子板盖➂ 并确保模块上的闩锁牢固地将端子板固定到位。注意：比较铰链门背面标签上的模块目录号（见图2-6）和模块侧面标签（见下文），以确保它们匹配。如果接线端子板安装在错误的模块类型上，则系统通电时可能会损坏模块。ABB IIMLM01
英文资料
Installing a Module’s Terminal Board Note: Modules IC693MDL730F (and later) and IC693MDL731F (and later) have special terminal boards that are equipped with holding screws. For Installation and Removal instructions, please see the section “Installing and Removing Terminal Boards with Holding Screws” later in this chapter. To install a terminal board (circled numbers refer to drawing below): Ŷ Hook the pivot hook ➀, located on the bottom of the terminal board, to the lower slot on the module. Ŷ Push the terminal board toward the module ➁ until it snaps into place. Ŷ Open the terminal board cover ➂ and ensure that the latch on the module is securely holding the terminal board in place. Caution Compare the module catalog number on the label on the back of the hinged door (see Figure 2-6) and the label on the side of the module (see below) to ensure that they match. If a wired terminal board is installed on the wrong module type, damage to the module may occur when the system is powered up.ABB IIMLM01
每 日 展 示
公 司 主 营 优 势
应 用 行 业
