ABB 07KR51-A3.6 1SBP260014R1001控制器
ABB 07KR51-A3.6 1SBP260014R1001当两个曲面之间共享边时，法线方向和切线方向取决于选定的曲面。3.使用以下变量指定目标如何与边缘上的点相关。注意！对于每个目标点，在图形窗口中，进场和行进矢量的预览显示为箭头和表示边缘上的点的球体。一旦变量被修改，箭头预览将动态更新。4.单击“删除”从列表框中删除目标点。选择到…垂直偏移指定曲面法线方向上从边缘到目标的距离ABB 07KR51-A3.6 1SBP260014R1001。横向偏移指定从边缘到垂直于边缘切线的目标的距离。接近角指定（反向）曲面法线与目标接近矢量之间的角度。反向移动方向指定目标的移动向量是与边切线平行还是反向平行。ABB 07KR51-A3.6 1SBP260014R1001
ABB 07KR51-A3.6 1SBP260014R1001When an edge is shared between two surfaces, the normal and tangent directions depend
on the surface selected.
3. Use the following variables to specify how a target is related to a point on the edge.
NOTE!
For each target point, a preview of the approach and travel vectors are displayed as arrows
and as a sphere representing the point on the edge in the graphics window. The preview
of the arrows are updated dynamically once the variables are modified.
4. Click Remove to remove the target points from the list box.
Select... to...
Vertical offset specify the distance from the edge to the target in the surface
normal direction.
Lateral offset specify the distance from the edge to the target perpendicular to
the edge tangent.
Approach angle specify the angle between the (inverse) surface normal and the
approach vector of the target.
Reverse travel direction specify if the travel vector of the target is parallel or inversely
parallel to the edge tangent.
