ABB SD821 3BSC610037R1驱动控制
从列表中选择控制器选项，控制器已自动检测到。指定电脑和机器人连接到同一网络的IP地址或控制器名称选项。您只能在DHCP网络中使用控制器名称。使用服务端口选项您的电脑直接连接到控制器的服务端口。或者，单击测试连接以确认计算机和控制器之间的连接正常。4。单击“加载”。5.对问题回答“是”是否要立即重新启动控制器？是控制器立即重新启动，下载的系统自动启动。否控制器不会立即重新启动。要开始使用下载的系统，您必须：1。执行C启动或X启动2。手动选择系统取消从控制器中删除下载的系统引导介质是整个系统，system Builder将其打包为单个文件，通常存储在硬盘或USB存储器上。然后，控制器分别通过其以太网端口或USB端口访问文件。
Select controller from list option the controller has been detected automatically.
Specify IP address or controller name
option
your PC and the robot is connected to the
same network.
You can only use the controller name in
DHCP networks.
Use service port option your PC is directly connected to the controller's service port.. Optionally, click Test Connection to confirm that the connection between the computer
and the Controller is OK.
4. Click Load.
5. Answer Yes to the question Do you want to restart the controller now?Yes The controller restarts immediately and the downloaded system starts
automatically.
No The controller does not restart immediately.
To start using the downloaded system, you have to:
1. perform a C-start or an X-start
2. select the system manually
Cancel The downloaded system is removed from the controller Boot media is an entire system which the System Builder packs to a single file and commonly
stores on a hard disk or USB memory. The controller then accesses the file through its
Ethernet port or USB port, respectively.
