TMS320VC5420PGE200DSP数字信号处理器
DIN导轨必须与机柜的PE（保护接地）良好连接。为了达到最佳的耐腐蚀性，DIN导轨应镀铬，例如，经黄铬处理。使用星形垫圈和用于将DIN导轨固定到安装板上的每个螺钉。要将DIN导轨固定到安装板上，最小螺钉直径为5 mm，螺钉之间的最大距离为100 mm。快速设置可引导您完成最少的步骤来设置张力电子设备。系统要求您回答一些问题并输入所需的值。必须进行这些选择和参数设置，以使张力电子设备准备好进行测量。在快速设置中仅设置有限数量的选择和参数设置。所有其他参数均设置为出厂默认值。参见附录A.4出厂默认设置。 The DIN-rail must have a good connection to the PE (Protective Earth) of the cabinet. To achieve the best possible corrosion resistance, DIN-rails should be chromium plated, for instance, yellow chromium treated. Use star washers with each screw used to fasten the DIN-rail to the mounting plate. To fasten the DIN-rail onto the mounting plate, the minimum screw diameter is 5 mm and the maximum distance between screws is 100 mm.The fast setup guides you through a minimum number of steps to set up the tension electronics. You are asked to answer some questions and to enter desired values. These selections and parameter settings must be made to get the tension electronics ready for measurement. Only a limited number of selections and parameter settings are set in the fast setup. All other parameters are set as factory default values. See Appendix A.4 Factory Default Settings.
