GE IC697PWR720 DCS系统备件
插值路径插值函数重新定向路径中的目标，使起始目标和结束目标之间的方向差均匀分布在其间的目标之间。插值可以是线性的，也可以是绝对的。线性插值根据目标沿路径长度的位置均匀分布方向差异。绝对插值基于路径中目标的顺序均匀分布方向差异。以下是线性插值和绝对插值之间的差异示例。插值函数重新定向路径中的目标，以便开始目标和结束目标之间的方向差均匀分布在中间的目标之间。插值可以是线性的，也可以是绝对的。有关过程，请参见第389页的插值路径。无插值这是任何插值之前的路径。请注意，最后一个目标的方向与其他目标不同
Interpolating a path
The interpolate functions reorient the targets in a path so that the difference in orientation
between the start and end targets is distributed evenly among the targets in between. The
interpolation can be either linear or absolute.
Linear interpolation distributes the difference in orientation evenly, based on the targets’
positions along the length of the path.
Absolute interpolation distributes the difference in orientation evenly, based on the targets’
sequence in the path.
Below are examples of the difference bewteen linear and absolute interpolation.
The interpolate functions reorient the targets in a path so that the difference in orientation
between the start and end targets is distributed evenly among the targets in between. The
interpolation can be either linear or absolute.
For a procedure, see Interpolate Path on page 389.
No interpolation
This is the path before any interpolation. Note that the last target is oriented differently than
the others
