EMERSON KJ3001X1-BA1控制主板卡件
下一个逻辑分区将从第一个硬盘驱动器开始分配驱动器号，依次为每个逻辑设备刻字，直到所有逻辑分区都分配了驱动器号。然后，系统将对第二个硬盘上的每个逻辑分区执行相同的顺序刻字。注意：添加额外驱动器或更改初始分区方案导致的驱动器号更改可能会导致更改之前安装的操作系统出现问题。在安装操作系统之前规划您的配置，以最大限度地减少远程以太网引导的困难VMIVME-7750能够通过使用Lanworks BootWare BIOS的网络使用LAN1或LAN2从服务器启动。BootWare BIOS使您能够使用各种网络协议远程启动VMIVME-7750。以太网必须通过LAN前面板（RJ-45）连接器连接才能远程启动。
The next logical partitions will be assigned drive
letters starting on the first hard drive, lettering each logical device sequentially, until
all are assigned a drive letter. The system will then perform the same sequential
lettering of each logical partition on the second hard disk.
NOTE: Drive letter changes caused by adding an additional drive or changing the
initial partitioning scheme may cause difficulties with an operating system installed
prior to the changes. Plan your configuration prior to installing the operating system
to minimize difficulties Remote Ethernet Booting
The VMIVME-7750 is capable of booting from a server using either LAN1 or LAN2
over a network utilizing Lanworks BootWare BIOS. The BootWare BIOS gives you the
ability to remotely boot the VMIVME-7750 using a variety of network protocols. The
Ethernet must be connected through either LAN front panel (RJ-45) connector to boot
remotely.
