EMERSON KJ1501X1-BK1模拟数字模块
闪存磁盘将配置为出厂时的单个分区设备。下面的示例序列说明了创建两个8MB分区的一种经过验证的方法，其中一个作为活动主分区。请注意退出FDISK的说明。这已被证明是成功分区工作的重要一步。1.通电VMIVME-7750并进入CMOS设置。2.将IDE HDD Master设置为“未安装”。将Flash Disk Master设置为“AUTO”（自动）。4.将引导设备设置为软盘。5.从软盘启动DOS，并验证系统配置屏幕是否仅显示闪存磁盘。6.运行FDISK。7.删除所有当前分区（当前存储在分区中的任何数据都将丢失）。8.退出FDISK（这将导致重新启动），然后再次运行FDISK。9.创建一个8M字节的主分区。10.创建一个8M字节的扩展分区。11.为8M字节扩展分区设置逻辑设备。12.将主分区设置为活动分区。13.退出FDISK
The Flash Disk will be configured as a single partition device as delivered from the
factory. The following sample sequence illustrates a proven method for creating two
8 Mbyte partitions, with one as an active primary partition. Take note of the
instructions to exit FDISK. This has been shown to be an important step in a
successful partitioning effort.
1. Power up the VMIVME-7750 and enter the CMOS set-up.
2. Set IDE HDD Master to “Not Installed”.3. Set Flash Disk Master to “AUTO”.
4. Set boot device to floppy.
5. Boot DOS from the floppy, and verify that the System Configuration Screen
shows only the Flash Disk.
6. Run FDISK.
7. Delete all current partitions (any data currently stored in the partitions will be
lost).
8. Exit FDISK (this will cause a reboot), then run FDISK again.
9. Create an 8 Mbyte primary partition.
10. Create an 8 Mbyte extended partition.
11. Set-up a logical device for the 8 Mbyte extended partition.
12. Set the Primary partition as an active partition.
13. Exit FDISK
