FOXBORO FBM206 P0916CQ控制器模块
如前所述,典型的系统包括VMIVME-7750,其驻留的闪存磁盘配置为次要IDE设备、连接到主要IDE接口的硬盘驱动器和连接到软盘接口的软盘驱动器。使用此配置,可能需要在任一IDE设备上具有逻辑设备,配置为可引导设备,允许通过高级CMOS设置屏幕选择第一个引导设备。使用此功能,用户可以使系统配置有多个操作系统,通过将IDE逻辑设备指定为引导设备,可以选择这些操作系统。DOS实用程序FDISK通常用于配置硬盘驱动器上的分区结构。下一页的注释与使用FDISK进行分区有关。注意:删除分区将擦除以前存储在该分区中的所有数据。
As discussed earlier, a typical system consists of the VMIVME-7750 with its resident
Flash Disk configured as the Secondary IDE device, a hard drive attached to the
Primary IDE interface, and a floppy drive attached to the floppy interface.
Using this configuration, it may be desirable to have a logical device on either IDE
device, configured as a bootable device, allowing the selection of the first boot device
by way of the Advanced CMOS Setup screen. Using this capability, a user could have
a system configured with multiple operating systems that would be selectable by
assigning the IDE logical device as the boot device.
The DOS utility FDISK is commonly used to configure the partition structure on a
hard drive. Comments on the following page pertain to partitioning efforts using
FDISK.
CAUTION: Deleting a partition will erase all the data previously stored in that
partition.