FOXBORO FBM201 P0914SQ电阻输入分压器编程
当这些字段中的任何一个被写入（通过单个32位写入或单独的16位写入）时，无论定时器是启用还是禁用，相应的定时器都会在定时器时钟的下一个上升沿加载写入值。存储在该寄存器中的值也会在计时器的终端计数（或超时）时自动重新加载。计时器3加载计数寄存器（TMRLCR3）计时器3为32位宽，并从计时器3加载计数器寄存器（TMLCR3）获得其加载计数，该寄存器位于BAR2中地址的偏移0x14处。此寄存器中的位映射如下：写入此字段时，无论计时器是启用还是禁用，计时器3都会在计时器时钟的下一个上升沿加载写入值。存储在该寄存器中的值也会在计时器的终端计数（或超时）时自动重新加载。计时器4加载计数寄存器（TMRLCR4）计时器4为32位宽，并从位于BAR2中地址偏移0x18处的计时器4加载计数器寄存器（TMLCR4）中获取其加载计数。此寄存器中的位映射如下：写入此字段时，无论计时器是启用还是禁用，计时器4都会在计时器时钟的下一个上升沿加载写入值。存储在该寄存器中的值也会在计时器的终端计数（或超时）时自动重新加载。
When either of these fields are written (either by a single 32-bit write or separate
16-bit writes), the respective timer is loaded with the written value on the next rising
edge of the timer clock, regardless of whether the timer is enabled or disabled. The
value stored in this register is also automatically reloaded on terminal count (or
timeout) of the timer.
Timer 3 Load Count Register (TMRLCR3)
Timer 3 is 32-bits wide and obtains its load count from the Timer 3 Load Count
Register (TMRLCR3), located at offset 0x14 from the address in BAR2. The mapping
of bits in this register are as follows:When this field is written, Timer 3 is loaded with the written value on the next rising
edge of the timer clock, regardless of whether the timer is enabled or disabled. The
value stored in this register is also automatically reloaded on terminal count (or
timeout) of the timer.Timer 4 Load Count Register (TMRLCR4)
Timer 4 is 32-bits wide and obtains its load count from the Timer 4 Load Count
Register (TMRLCR4), located at offset 0x18 from the address in BAR2. The mapping
of bits in this register are as follows:
When this field is written, Timer 4 is loaded with the written value on the next rising
edge of the timer clock, regardless of whether the timer is enabled or disabled. The
value stored in this register is also automatically reloaded on terminal count (or
timeout) of the timer.
