EMERSON 1C31125G01 DCS卡
SEEPROM地址开关，S1一个4位SMT配置开关位于MVME7216E转换模块上，用于设置RTM串行EEPROM设备的设备地址。下表“后面板连接器”中定义了开关设置。MVME7216E转换模块提供了这些连接器。所有连接器均使用符合VME总线规范的标准引脚分配。PIM I/O（PIM）连接器J10仅从VME P2连接器布线电源和接地。此连接器上没有主机I/O信号。MVME7100将PMC I/O从PMC插槽1的J14路由到VME P2的A和C行。MVME7216E将这些信号（针对针）从VME P2路由到PMC I/O模块连接器J14。ACT活动或以太网或千兆E以太网连接器速度10/100/1000Mb/s以太网连接器有两组ACT和SPEED LED，每个以太网连接器一组。下表对其进行了描述。VME7216E PMC I/O模块（PIM）连接器（J10、J14）PMC主机I/O连接器J10仅从VME P2路由电源和接地。此连接器上没有主机I/O信号。MVME7100将PMC I/O从PMC插槽1的J14路由至VME P2 A和C行。MVME7216E将这些信号（针对针）从VME P2路由至PMC I/O模块连接器J14。引脚分配见表5-6和表3-8。
SEEPROM Address Switch, S1 A 4-position SMT configuration switch is located on the MVME7216E transition module to set the device address of the RTM serial EEPROM device. The switch settings are defined in the next table Rear Panel Connectors The MVME7216E transition module provides these connectors. All connectors use standard pin assignments in compliance with the VMEbus specifications.PMC I/O (PIM) connector J10 routes only power and ground from VME P2 connector. There are no host I/O signals on this connector. The MVME7100 routes PMC I/O from J14 of PMC Slot 1 to VME P2 rows A and C. The MVME7216E routes these signals (pin-for-pin) from VME P2 to PMC I/O module connector J14.ACT Activity or Ethernet or Gigabit E Ethernet connector SPEED 10/100/1000Mb/s of Ethernet connectors There are two sets of ACT and SPEED LEDs, one set for each Ethernet connector. They are described in the next table.MVME7216E PMC I/O Module (PIM) Connectors (J10, J14) PMC host I/O connector J10 routes only power and ground from VME P2. There are no host I/O signals on this connector. The MVME7100 routes PMC I/O from J14 of PMC Slot 1 to VME P2 rows A and C. The MVME7216E routes these signals (pin-for-pin) from VME P2 to PMC I/O Module connector J14. See Table 5-6 and Table 3-8 for the pin assignments.
