EMERSON KJ3206X1-BA1控制系统模块
GNET1 SPEED TSEC1链路/速度前面板关闭黄色绿色无链路10/100 BASE-T操作1000 BASE-T操作GNET1 ACT TSEC1活动前面板关闭闪烁绿色无活动与带宽利用率成正比的活动GNET2 SPEED TSEC2链路/速度后面板关闭黄色绿色无链路10/100BASE-T操作1000BASE-T操作GNDET2 ACT TSEC2活动前面板不闪烁绿色无活动与带宽利用率成正比的活动连接器本节介绍了MVME7100上连接器的引脚分配和信号。下表列出了MVME7100基板上的标准连接器。有关连接器位置，请参阅第47页的图3-1。连接器的端号分配在以下部分中。一些连接器使用符合VMEbus、IEEE、PCI和ANSI/VITA规范的标准引脚分配。这些规范的链接
GNET1 SPEED TSEC1 Link / Speed Front panel Off Yellow Green No link 10/100 BASE-T operation 1000 BASE-T operation GNET1 ACT TSEC1Activity Front panel Off Blinking Green No activity Activity proportional to bandwidth utilization GNET2 SPEED TSEC2 Link / Speed Front panel Off Yellow Green No link 10/100 BASE-T operation 1000 BASE-T operation GNET2 ACT TSEC2 Activity Front panel Off Blinking Green No activity Activity proportional to bandwidth utilization Connectors This section describes the pin assignments and signals for the connectors on the MVME7100. The next table lists the standard connectors on the MVME7100 baseboard. Refer to Figure 3-1 on page 47 for connector locations. Pin assignments for the connectors are in the following sections. Some connectors use standard pin assignments in compliance with the VMEbus, IEEE, PCI, and ANSI/VITA specifications. Links to these specifications
