EMERSON VE4002S1T2B3离散输出卡
如果有疑问，请咨询系统管理员。MVME7100的控制台设置如下： 每个字符八位 每个字符一个停止位 奇偶校验已禁用（无奇偶校验） 9600波特的波特率验证是否安装了硬件，以及连接的电源/外围设备电缆是否适合您的系统配置。装回机箱或系统护盖，将机箱重新连接到交流或直流电源，然后打开设备电源。工厂安装的Linux基于2.6.25内核的可启动ramdisk Linux映像可在NOR闪存中使用。要启动此映像，请使用以下MOTLOAD命令：file提供了MVME7100 Linux的简要概述。有关使用MVME7100 Linux的内核补丁和其他信息，请联系SMART Embedded Computing。概述本章概述了MVME71000基板的控件、LED、连接器和标头。MVME7216E转换模块的连接器可在Board Layout中找到。下图显示了MVME7100上的组件、LED、连接器和复位开关。
If in doubt, ask your system administrator. The console settings for the MVME7100 are: Eight bits per character One stop bit per character Parity disabled (no parity) Baud rate of 9600 baud Verify that hardware is installed and the power/peripheral cables connected are appropriate for your system configuration. Replace the chassis or system cover, reconnect the chassis to the AC or DC power source, and turn the equipment power on.Factory Installed Linux A bootable ramdisk based Linux image based on the 2.6.25 kernel is available in NOR flash. To boot this image, use the following MOTLOAD commands:file provides a brief overview of MVME7100 Linux. Contact SMART Embedded Computing for kernel patches and additional information on using MVME7100 Linux.Overview This chapter summarizes the controls, LEDs, connectors, and headers for the MVME7100 baseboard. Connectors for the MVME7216E transition module can be found Board Layout The following figure shows the components, LEDs, connectors, and the reset switch on the MVME7100.
