GE DS200TCQAG1BEC电源板系统模块
安装附件本节介绍了在底板上安装MVME7216E转换模块、PMC和XMCspan的步骤。2.5.1转换模块MVME7216E不支持热插拔。在安装模块之前，应断开后插槽或系统的电源。在安装MVME7216E转换模块之前，您可能需要手动配置交换机并安装PMC I/O模块（PIM）。参见第5章，转换模块，了解开关设置和PIM安装。电路损坏静电放电和不正确的安装和拆卸会损坏电路或缩短电路寿命。在接触电路板或电子元件之前，请确保您在ESD安全环境中工作。产品损坏仅使用注射器手柄插入电路板，以避免损坏前面板和/或PCB。前面板变形可能导致电气短路或其他电路板故障。
Installing Accessories This section describes the procedures for installing the MVME7216E transition module, PMCs, and the XMCspan on the baseboard. 2.5.1 Transition Module The MVME7216E does not support hot swap, You should remove power to the rear slot or system before installing the module. Before installing the MVME7216E transition module, you may need to manually configure the switch and install a PMC I/O Module (PIM). Refer to Chapter 5, Transition Module, for switch settings and PIM installation.Damage of Circuits Electrostatic discharge and incorrect installation and removal can damage circuits or shorten their life. Before touching the board or electronic components, make sure that you are working in an ESD-safe environment. Product Damage Only use injector handles for board insertion to avoid damage to the front panel and/or PCB. Deformation of the front panel can cause an electrical short or other board malfunction.
