GE DS200FCRRG1AKD电路板
终端接收机的脉冲接受能力：该参数通常表示为以下任一项：（a）每需求间隔的脉冲数；（b） 每秒、分钟或小时的脉冲数；（c） 触点连续闭合之间的最短时间。6.脉冲接收器类型：有4种基本类型的脉冲接收器：a）三线，每个脉冲计数；b） 三线，每隔一次脉冲计数；c） 双导线，A型常开，仅对每个触点闭合进行计数；d） 双线，计数每个状态变化，即识别触点闭合和触点断开。7.在定义的时间间隔内消耗的最大能量：这基于系统参数，并定义了在特定时间内可能累积的最大能量。使用KYZ端子将PQM脉冲输出继电器应用于终端接收器：根据接收器类型，典型的终端接收器需要KY或KZ之间的触点闭合。PQM脉冲输出功能可用于两线或三线连接。PQM在定义的脉冲输出宽度的定义脉冲输出间隔的每次累积时激活指定的输出继电器。
Pulse Acceptance Capability of the end Receiver: This parameter is normally expressed as any one of the following: (a) Pulses per Demand Interval; (b) Pulses per second, minute or hour; (c) Minimum time between successive closures of the contacts. 6. Type of Pulse Receiver: There are 4 basic types of Pulse receivers: a) Three-wire, every pulse counting; b) Three-wire, every other pulse counting; c) Two-wire, Form A normally open, counts only each contact closure; d) Two-wire, counts every state change, i.e. recognizes both contact closure and contact opening. 7. Maximum Energy Consumed over a defined interval: This is based upon system parameters and defines the maximum amount of energy that may be accumulated over a specific time. Application of the PQM Pulse Output Relays to an End Receiver Using KYZ Terminals: Typical end receivers require a contact closure between KY or KZ based upon the type of receiver. The PQM Pulse Output feature can be used with either two- or three-wire connections. The PQM activates the designated Output Relay at each accumulation of the defined Pulse Output Interval for the defined Pulse Output Width.
