GE DS200GDPAG1AKF高频电源板
更改“财产”窗口中的设置以匹配上面显示的设置，然后单击“确定”。您现在应该有一个指向PQM的链接。在超级终端的文本窗口中输入大写的文本LOAD。键入“E”清除PQM闪存。9.超级终端将要求您验证是否要擦除闪存；输入“Y”表示是。完成后，Boot Menu（引导菜单）再次出现。10.现在选择“B”以空白检查闪存；完成后，PQM启动菜单将再次出现。11.键入“U”将软件上传到PQM。PQM现在正在等待您发送固件文件。在超级终端任务栏上选择“传输”，然后选择“发送文件”，将出现以下窗口。输入要发送到PQM的固件文件的位置和名称，并确保协议为1KX调制解调器，然后单击发送。PQM现在将继续接收固件文件，这通常需要3到4分钟。完成后，Boot Menu（引导菜单）将再次出现。
Change the settings in the Properties window to match those shown above, and click on OK. You should now have a link to the PQM. Enter the text LOAD in uppercase in the text window of Hyperterminal.8. Type “E” to Erase the PQM flash memory. 9. HyperTerminal will ask you to verify that you wish to erase the flash memory; enter “Y” for yes. The Boot Menu appears again when complete. 10. Now select “B” to blank check the flash memory; the PQM Boot Menu will appear again when complete. 11. Type “U” to upload software to the PQM. The PQM is now waiting for you to send a firmware file. Select “Transfer” and then “Send File” on the Hyperterminal task bar and the following window will appear.Enter the location and the name of the firmware file you wish to send to the PQM, and ensure the Protocol is 1KXmodem, and click on Send. The PQM will now proceed to receive the firmware file, this usually takes 3 to 4 minutes. When complete the Boot Menu will again appear.
