GE DS200GGDAG1AHE闸门驱动板
有两种方法可以缓解这种情况：一种是循环向PQM供电；第二种是使用终端程序（如超级终端）与PQM接口，并手动执行上传过程。循环断电，然后重新向PQM施加控制电源。然后PQM应在其闪存中运行现有固件。如果PQM未在闪存中运行固件，请尝试使用超级终端的第二种方法。超级终端1。超级终端是Microsoft Windows提供的终端接口程序。运行程序“hypertrm.exe”，该程序通常位于PC的“附件”文件夹中。将出现一个Connection Description（连接描述）窗口，要求输入名称，为连接使用PQM等名称，然后单击OK（确定）。出现以下窗口。4.选择连接到PQM的PC的通信端口，然后单击“确定”。接下来将显示以下窗口。
There are two ways to alleviate this condition: one is to cycle power to the PQM; the second is to interface with the PQM using a terminal program, such as Hyperterminal, and perform the upload process manually. Cycling Power Remove and then re-apply control power to the PQM. The PQM should then run the existing firmware in its flash memory. If the PQM does not run the firmware in flash memory, attempt the second method using Hyperterminal. Hyperterminal 1. Hyperterminal is a terminal interface program supplied with Microsoft Windows. Run the program “hypertrm.exe” which is usually located in the Accessories folder of your PC. 2. A Connection Description window will appear asking for a name, use a name such as PQM for the connection and click on OK. The following window appears. 4. Select the communications port of your PC that is connected to the PQM and click on OK. 5. The following window appears next.
