GE DS200IQXSG1AAA燃机模块
使用功能代码9和10只能清除计数器点0至4，这样做会干扰显示器上显示的总数和Modbus通信。通常，如果有必要清除这些计数器中的任何一个，应使用清除数据的二进制输出点。只能使用功能代码9和10清除计数器点0至4，这样做会干扰显示器上显示的总数和Modbus通信。一般来说如果有必要清除这些计数器中的任何一个，则应使用清除数据的二进制输出点。需求监控规格已更正1.3.1电压输入精度规格已更新1.3.1欠频/过频监控定时精度规格已更改1.3.1测量值精度：已全部更改为满量程1.3.1电流输入精度的+/-0.4%1.3.1电压输入-将VT PRI/SEC更改为VT输入，并相应地更改数据1.3.1在Trace Memory TRIGGER（跟踪存储器触发器）下添加跟踪存储器拾取精度规范，2.2.7创建并插入图纸823700A1 2.2.6在开关输入部分的开始描述中添加注释
Only counter points 0 to 4 can be cleared using function codes 9 and 10, and doing so disturbs the totals presented on the display and via Modbus communications. In general, the binary output points which clear data should be used if it is necessary to clear any of these counters.Only counter points 0 to 4 can be cleared using function codes 9 and 10, and doing so disturbs the totals presented on the display and via Modbus communications. In general, the binary output points which clear data should be used if it is necessary to clear any of these counters.Demand Monitoring specs corrected 1.3.1 VOLTAGE INPUTS Accuracy specification updated 1.3.1 UNDERFREQUENCY/OVERFREQUENCY MONITORING Timing Accuracy specs changed 1.3.1 Measured Values Accuracy: Changed all to +/-0.4% of Full Scale 1.3.1 CURRENT INPUTS Accuracy change 1.3.1 VOLTAGE INPUTS - changed VT PRI/SEC to VT Input and changed data accordingly 1.3.1 Added Trace Memory Pickup Accuracy specs under TRACE MEMORY TRIGGER, 2.2.7 Drawing 823700A1 created and inserted 2.2.6 Note to be added to the beginning description of the switch input section
