GE DS200LPPAG1ABA线路保护卡
二进制输入和模拟输入对象的点表包含一个字段，该字段定义了对应的静态数据已分配给哪个事件类。对于此对象，限定符代码只能指定索引7。5.支持热重启（功能代码14），尽管DNP 2级规范不要求。6.对象1变体1始终指示所有点的在线。默认变体下表指定了继电器返回的所有对象的默认变体。这些是当请求中未指定特定变化时，将在响应中为对象返回的变化。1二进制输入-单个位1 2二进制输入随时间变化2 10二进制输出状态2 12控制继电器输出块1 20 16位二进制计数器无标志5 30 16位模拟输入无标志2 32 16位模拟输出无时间变化2内部指示位支持以下内部指示位：设备重启——在PQM通电时设置，通过向对象80 0 4写入零来清除需要时间——每当PQM出现“CLOCK NOT set”（时钟未设置）警报时设置，并通过设置时钟0 1 Class 1来清除——表示1类事件可用
The point tables for Binary Input and Analog Input objects contain a field which defines which event class the corresponding static data has been assigned to. 4. For this object, the qualifier code must specify an index of 7 only. 5. Warm Restart (function code 14) is supported although it is not required by the DNP level 2 specification. 6. Object 1 Variation 1 always indicates ON LINE for all points.Default Variations The following table specifies the default variation for all objects returned by the relay. These are the variations that will be returned for the object in a response when no specific variation is specified in a request.1 Binary Input - Single Bit 1 2 Binary Input Change With Time 2 10 Binary Output Status 2 12 Control Relay Output Block 1 20 16-Bit Binary Counter Without Flag 5 30 16-Bit Analog Input Without Flag 2 32 16-Bit Analog Input Change Without Time 2 Internal Indication Bits The following internal indication bits are supported:Device Restart -- set when PQM powers up, cleared by writing zero to object 80 0 4 Need Time -- set whenever the PQM has a “CLOCK NOT SET” alarm, cleared by setting the clock 0 1 Class 1 -- indicates that class 1 events are available
