GE DS200PCCAG5ACB过程变量监测器模块
*由于功率因数均存在–0和+0，PQM串行寄存器中存储的值与显示器上显示的值相反。示例：如果需要0.23超前（-0.23）至0.35滞后（+0.35）的范围，必须发送–77（–100+23）和+65（100–35）。设备配置文件文件配置为DNP从端口的通信端口必须支持子集定义第2章中描述的第2级DNP V3.00实施（DNP-L2）中列出的全部功能。实施表下表列出了PQM识别和返回的所有对象。以下页面提供的其他信息包括默认变量列表和为每个对象返回的定义点数。对于此对象，请求中指定的数量必须正好为1，因为中继中只定义了此对象的一个实例。2.响应于0类的请求，返回继电器已知的所有静态输入数据。这包括类型1（二进制输入）和类型30（模拟输入）的所有对象。
*Due to the fact that –0 and +0 both exist for power factor, the value stored in the PQM serial register is the opposite of the value shown on the display. Example: If the range 0.23 lead (–0.23) to 0.35 lag (+0.35) is required, –77 (–100+23)and +65 (100–35) must be sent.Device Profile Document The communications port configured as a DNP slave port must support the full set of features listed in the Level 2 DNP V3.00 Implementation (DNP-L2) described in Chapter 2 of the subset definitions.Implementation Table The table below lists all objects recognized and returned by the PQM. Additional information provided on the following pages includes lists of the default variations and defined point numbers returned for each object.Implementation Table Notes: 1. For this object, the quantity specified in the request must be exactly 1 as there is only one instance of this object defined in the relay. 2. All static input data known to the relay is returned in response to a request for Class 0. This includes all objects of type 1 (Binary Input) and type 30 (Analog Input).
