GE DS200SDCIG2AFB涡轮机控制电源板
选择“实际”>“功率分析”>“跟踪内存”菜单项以查看跟踪内存数据。这将启动下面显示的跟踪内存波形窗口。使用触发选定跟踪按钮强制触发跟踪内存触发。如果“触发模式”设置为“一次触发”，则使用“重新防护所有轨迹”按钮在填充所有缓冲区后重新触发。按下此按钮将使跟踪内存默认返回第一个缓冲区。“从设备读取所选痕迹”按钮加载并查看以前捕获的数据。对于“选择缓冲区”选项，选择1、2或3以显示三个不同缓冲区之一。此选项取决于在设定点>PQM选项菜单项中选择的触发模式。打开加载先前保存的波形以供查看，保存将捕获的波形保存到文件，打印打印当前波形，设置允许配置捕获参数。
Select the Actual > Power Analysis > Trace Memory menu item to view the trace memory data. This launches the Trace Memory Waveform window shown below.Use the Trigger Selected Traces button to force a trace memory trigger. Use the Re-Arm All Traces button to re-trigger after all the buffers have been filled if the Trigger Mode has been set to One-Shot. Pressing this button causes the trace memory to default back to the first buffer. The Read Selected Traces From Device button loads and views previously captured data. For the Select Buffer option, select 1, 2, or 3 to display one of the three different buffers. This option is dependent on the Trigger Mode selected in the Setpoint > PQM Options menu item.Open loads previously saved waveforms for viewing, Save saves the captured waveforms to a file, Print prints the current waveforms, and Setup allows for the configuration of capture parameters.
