FOXBORO FBM237 P0914XS输出模块
存储键编程设定点时，使用和键输入新值，然后按键。必须启用设定点编程，以便按键存储编辑值。如果新设定点成功保存在非易失性存储器中，确认消息将闪烁。该键还用于添加和删除用户定义的默认消息。有关更多详细信息，请参阅第9页第3.4节：默认消息。重置键该键用于清除锁定报警和/或辅助条件。当按下该键时，PQM将根据下表所示的条件执行适当的操作。无未采取任何措施报警报警指示灯和报警继电器保持打开，因为条件仍然存在辅助继电器辅助指示灯和辅助继电器保持打开条件仍然存在
Store Key When programming setpoints, enter the new value using the and keys, followed by the key. Setpoint programming must be enabled for the key to store the edited value. An acknowledgment message will flash if the new setpoint is successfully saved in non-volatile memory. The key is also used to add and remove user defined default messages. Refer to Section 3.4: Default Messages on page –9 for further details.Reset Key The key is used to clear the latched alarm and/or auxiliary conditions. Upon pressing the key, the PQM will perform the appropriate action based on the condition present as shown in the table below.None No action taken Alarm ALARM indicators and alarm relay remain on because condition is still present Aux Relay AUXILIARY indicator(s) and aux relay(s) remain on because condition is still present Alarm and Aux Relay AUXILIARY and ALARM indicators and alarm and aux relays remain on because condition is still present
转载请附上此链接：http://www.jiangxidcs.com/
