IS200EPSMG2A GE M2LR机器人备件,DCS工控模块备件
输出1.0毫秒输出0.5毫秒输入阻抗5.6K欧姆（24/48V）、5.6K欧姆，3.3 K ohms 1.8K ohms（24V）1.8K ohm（24V）1.8 K ohms在开关设备处的开关设备处输入诊断：输入诊断：，故障开关输出故障开关输出失败开关输出故障切换输出故障开关脉冲测试诊断：短路诊断：短路故障诊断：短路、过载、电路、过载、断路、过载、过载、负载、故障开关、负载、开关故障、负载、，脉冲试验脉冲试验脉冲测试工作电压18-56 VDC（24/48 V）18-56 VDC，（24/48）18-30 VDC）3.94英寸（10.00cm）3.94“（10.00cm）3.94”（10.00cm。。。保证Genius 206 GE Fanuc控制器和I/O解决方案Genius DC离散I/O块与各种输入设备接口，包括2线和3线电子接近开关。输出可能是低功率控制和指示设备，如继电器、接触器和灯。这些模块具有相同的离散I/O电路，每个电路都可以很容易地用作输入或输出。输出电路可以直接连接到输入电路，而无需使用其他组件或逻辑状态反转。这种灵活性提供了设计和应用效率。当用作输出时，每个电路都包含内置保护，在允许短时浪涌的同时保护驱动器。它还可以防止因接线错误而导致的短路负载。DC离散I/O模块IC660BBD025 IC660BBS102 IC660BBS103 IC660BBR100 IC660BBR01产品名称Genius离散I/O块、Genius离散输入/输出块、Genius离散I/O块，Genius继电器输出块，Genius继电器输出块、5/12/24 VDC分组、115 VAC/125 VDC隔离、115 VAV/125 VDC隔离，分组，16点，分组，w/o故障常闭常开开关诊断网络支持Genius总线Genius总线Genius总线Genus总线输入范围闭合继电器断开继电器点数32 8 8 16 16输入和输出响应时间-输入1.4毫秒加输入2毫秒加输入2msec加5.0毫秒。5.0毫秒。ON/OFF（毫秒）可配置滤波器：可配置滤波器可配置滤波器1至100mS用于输入；10mS内10至100mS 10mS内输出0.5毫秒增量；输出增量；输出零交叉零交叉输入阻抗3.3 K ohms 13K ohms 13 K ohms每个公共点每点负载电流一组32个四组2个四组4个四组保护
Output 1.0 msec Output 0.5 msec Input Impedance 5.6K ohms (24/48V), 5.6K ohms (24/48V), 5.6K ohms (24/48V), 5.6K ohms (24/48V), 3.3 K ohms 1.8K ohms (24V) 1.8K ohms (24V) 1.8K ohms (24V) 1.8K ohms (24V) Load Current Per Point 2 Amp 2 Amp 2 Amp 2 Amp 0.5 Amp Points Per Common One group of 16 One group of 16 One group of 16 One group of 16 One group of 32 Protection Short circuit level sensor Short circuit level sensor Short circuit level sensor Short circuit level sensor Short circuit level sensor at the switching device at the switching device at the switching device at the switching device at the switching device Diagstics Input Diagstics: Input Diagstics: Input Diagstics: Input Diagstics: Output Diagstics: Open wire, Open wire, Open wire, Open wire, Short Circuit, Overtemperature, Overtemperature, Overtemperature, Overtemperature, Overload, Failed Switch, Failed Switch Output Failed Switch Output Failed Switch Output Failed Switch Output Pulse Test Diagstics: Short Diagstics: Short Diagstics: Short Diagstics: Short Circuit, Overload, Circuit, Overload, Circuit, Overload, Circuit, Overload, Load, Failed Switch, Load, Failed Switch, Load, Failed Switch, Load, Failed Switch, Overtemperature, Overtemperature, Overtemperature, Overtemperature, Pulse Test Pulse Test Pulse Test Pulse Test Operating Voltage 18-56 VDC (24/48 V) 18-56 VDC (24/48 V) 18-30 VDC (24 V) 18-30 VDC (24 V) 10-30 VDC Dimensions (H x W x D) 8.83” (22.44cm) x 8.83” (22.44cm) x 8.83” (22.44cm) x 8.83” (22.44cm) x 8.83” (22.44cm) x 3.50” (8.89cm) x 3.50” (8.89cm) x 3.50” (8.89cm) x 3.50” (8.89cm) x 3.50” (8.89cm) x 3.94” (10.00cm) 3.94” (10.00cm) 3.94” (10.00cm) 3.94” (10.00cm) 3.94” (10.00cm) Artisan Techlogy Group - Quality Instrumentation ... Guaranteed Genius 206 GE Fanuc Controller and I/O Solutions Genius DC Discrete I/O blocks interface to a wide range of input devices, including both 2–wire and 3–wire electronic proximity switches. Outputs may be low–power control and indicating devices such as relays, contactors, and lamps. These blocks have identical discrete I/O circuits, each easily cond to be an input or an output. Output circuits can be directly connected to input circuits without the use of other components or inversion of logic states. This flexibility provides design and application efficiency. Each circuit contains built–in protection when used as an output, protecting the driver while allowing short–time surges. It also protects against shorted loads caused by wiring errors. DC Discrete I/O Modules IC660BBD025 IC660BBS102 IC660BBS103 IC660BBR100 IC660BBR101 Product Name Genius Discrete I/O Block, Genius Discrete I/O Block, Genius Discrete I/O Block, Genius Relay Output Block, Genius Relay Output Block, 5/12/24 VDC Grouped, 115 VAC/125 VDC Isolated, 115 VAC/125 VDC Isolated, Grouped, 16 Points, Grouped, 16 Points, 32 Point, Sink 8 Point 8 Point, w/o Failed rmally Closed rmally Open Switch Diagstic Network Support Genius Bus Genius Bus Genius Bus Genius Bus Genius Bus Input Range Closed Relays Open Relays Number of Points 32 8 8 16 16 Input and Output Response Time - Input 1.4 msec plus Input 2msec plus Input 2msec plus 5.0 msec. 5.0 msec. ON/OFF (msec.) configurable filter: configurable filter configurable filter 1 to 100mS for input; 10 to 100mS in 10mS 10 to 100mS in 10mS Output 0.5 msec increments; Outputs increments; Outputs Zero crossing Zero crossing Input Impedance 3.3 K ohms 13K ohms 13K ohms Load Current Per Point Points Per Common One group of 32 Four groups of 2 Four groups of 2 Four groups of 4 Four groups of 4 Protection
