IS200RAPAG1BCA机械设备卡件,工控卡件
最多可将64个节点连接到DeviceNet网络，而无需桥接或路由。有关DeviceNet NIU的信息，请参阅GFK-1533《VersaMax系统DeviceNet网络通信用户手册》。Profibus NIU ProfibusNIU（IC200PBI001）作为Profibus-DP网络上的从设备运行，自动与主设备交换状态、控制和诊断数据。NIU能够处理多达375字节的数据，包括多达244字节的离散和模拟输入数据以及多达244字节离散和模拟输出数据。系统主机可以是能够作为总线主机操作的任何设备。有关Profibus DP NIU的信息，请参阅GFK-1534，VersaMax System Profibus网络模块用户手册（A版或更高版本）。Genius NIU Genius NIU（IC200GBI001）作为Genius总线上的设备运行。NIU能够处理多达128字节的离散和模拟输入数据以及128字节的分立和模拟输出数据。系统主机可以是能够控制Genius总线的任何PLC或计算机。有关Genius NIU的信息，请参阅GFK-1535，VersaMax System Genius网络接口单元用户手册。1-8 VersaMax模块、电源和托架用户手册GFK-1504N 1电源交流或直流电源模块直接安装在CPU或NIU上。电源为工作站中的模块提供+5V和+3.3V电源。如果需要，可以在特殊的增压器托架上安装额外的电源，用于模块数量导致需要增压器的系统。CPU或NIU上的交流或直流电源与Booster载体上的电源必须共享相同的外部电源。IC200PWR001 VDC+INPUT-24 VDC，11 W电源未使用可用电源和托架下表列出了可用的VersaMax电源和托架。24VDC电源IC200PWR001 24VDC扩展3.3V电源IC200PWR002 120/240VAC电源IC200BWR101 120/240VDC扩展3.3V电压IC200PWR102 12VDC电源IC200FWR201 12VDC扩展3.3V电源IC200PWM R202电源升压托架IC200PWB001电源在本手册第3章中进行了描述。GFK-1504N第1章简介1-9 1模块VersaMax IO和选件模块的尺寸约为110 mm（4.3英寸）乘66.8 mm（2.63英寸）。模块可以水平或垂直安装在几种可用载体上。模块的深度为50毫米（1.956英寸），不包括托架或配合连接器的高度。66.8mm（2.63in）110mm（4.33in）分立模块上的单个点LED锁存器现场电源LED指示存在外部电源的电源OK LED指示存在VersaMax电源的电源颜色代码：红色：AC蓝色：DC金色：混合灰色：模拟/其他模块描述1234567 831 FLD PWR OK IC200MDL750 OUTPUT 12/24VDC POS GRP。本节讨论的5A 32PT OK FLD PWR VersaMax模块手册按模块类型分为章节。有关特定模块的更多信息，请参阅模块说明的目录或索引。离散模块点LED离散模块上的单个点LED可一目了然地提供状态信息。模块上的激光标记可识别LED。无论模块是否简单，点LED的位置始终与模块的接线图相对应：1-10 VersaMax模块、电源和托架用户手册GFK-1504N 1 LED用于离散混合模块IC200MDD845 Q（输出）点编号I（输入）第1章简介1-11 1可用模块离散输入模块输入模块，120VAC 8 IC200MDL140输入模块，240VAC 8 IC200MDL141输入模块、120VAC隔离8 IC200MDL 143输入模块、240VAC隔离4 IC200MDL144输入模块、120 VAC 16 IC200MDL240输入模块、240 VAC16 IC200MDL241输入模块、20 VAC隔离16 IC200MDL 243输入模块、24 VAC隔离8 IC 200MDL244输入模块、125 VDC正/负逻辑隔离8 IC200DL631输入模块、，125VDC正/负逻辑隔离16 IC200MDL632输入模块、48VDC正/负极逻辑组16 IC200MDL 635输入模块，
Up to 64 nodes can be connected to a DeviceNet network without bridging or routing. For information about the DeviceNet NIU, refer to GFK-1533, VersaMax System DeviceNet Network Communications User’s Manual. Profibus NIU The Profibus NIU (IC200PBI001) operates as a slave on a Profibus-DP Network, automatically exchanging , status, control, and diagnostic data with a master device. The NIU is capable of handling up to 375 bytes of data, consisting of up to 244 bytes of discrete and analog input data and up to 244 bytes of discrete and analog output data. The system host can be any device capable of operating as a bus master. For information about the Profibus-DP NIU, refer to GFK-1534, VersaMax System Profibus Network Modules User’s Manual (revision A or later). Genius NIU The Genius NIU (IC200GBI001) operates as a device on a Genius bus. The NIU is capable of handling up to 128 bytes of discrete and analog input data and 128 bytes of discrete and analog output data. The system host can be any PLC or computer capable of controlling the Genius bus. For information about the Genius NIU, refer to GFK-1535, VersaMax System Genius Network Interface Unit User’s Manual. 1-8 VersaMax Modules, Power Supplies and CarriersUser Manual GFK-1504N 1 Power Supplies An AC or DC Power Supply module installs directly on the CPU or NIU. The power supply provides +5V and +3.3V power to the modules in the station. Additional power supplies can be installed on special booster carriers, if needed, for systems where the number of modules creates the need for a booster. The AC or DC power supply on the CPU or NIU and the power supply that resides on the Booster carrier must share the same external power source. IC200PWR001 VDC + INPUT - 24 VDC, 11 W POWER SUPPLY NOT USED Available Power Supplies and Carrier The following table lists the available VersaMax power supplies and carrier. 24VDC Power Supply IC200PWR001 24VDC Expanded 3.3V Power Supply IC200PWR002 120/240VAC Power Supply IC200PWR101 120/240VAC Expanded 3.3V Power Supply IC200PWR102 12VDC Power Supply IC200PWR201 12VDC Expanded 3.3V Power Supply IC200PWR202 Power Supply Booster Carrier IC200PWB001 Power supplies are described in chapter 3 of this manual. GFK-1504N Chapter 1 Introduction 1-9 1 Modules VersaMax IO and option modules are approximately 110 mm (4.3 in) by 66.8 mm (2.63 in) in size. Modules can be mounted either horizontally or vertically on several types of available Carriers. Modules are 50 mm (1.956 in) in depth, not including the height of the carrier or the mating connectors. 66.8mm (2.63in) 110mm (4.33in) Individual Point LEDS Latch on Discrete Modules Field Power LED indicates presence of power from external supply OK LED indicates presence of power from VersaMax power supply Color code: Red: AC Blue: DC Gold: Mixed Gray: Analog/other Module Description 1234567 831 FLD PWR OK IC200MDL750 OUTPUT 12/24VDC POS GRP .5A 32PT OK FLD PWR VersaMax modules discussed in this manual are grouped into chapters by module type. For more information about a specific module, refer to the Table of Contents or Index for the module description. Discrete Module Point LEDs Individual point LEDs on discrete modules provide status information at a glance. Laser markings on the module identify the LEDs. The positions of the point LEDs always correspond to the module’s wiring diagram, whether the module is simple: 1-10 VersaMax Modules, Power Supplies and CarriersUser Manual GFK-1504N 1 LEDs for Discrete Mixed Module IC200MDD845 Q (output ) Point numbers I (input ) Chapter 1 Introduction 1-11 1 Available Modules Discrete Input Modules Input Module, 120VAC 8 IC200MDL140 Input Module, 240VAC 8 IC200MDL141 Input Module, 120VAC Isolated 8 IC200MDL143 Input Module, 240VAC Isolated 4 IC200MDL144 Input Module, 120VAC 16 IC200MDL240 Input Module, 240VAC16 IC200MDL241 Input Module, 120VAC Isolated 16 IC200MDL243 Input Module, 240VAC Isolated 8 IC200MDL244 Input Module, 125VDC Positive/Negative Logic Isolated 8 IC200MDL631 Input Module, 125VDC Positive/Negative Logic Isolated 16 IC200MDL632 Input Module, 48VDC Positive/Negative Logic Grouped 16 IC200MDL635 Input Module,
