MVME162-010工控备件模块
环境温度环境温度[A]额定电源电流取决于温度40°C[A]无吸50°C[A]Ie过载保护章程IEC 60947-4-1电机保护（类别号-C2N、-D8N、-F8N除外）IEC 60947环境温度补偿[°C]-20+60相损耗保护差动脱扣器10级（类别号-C2N、-D8N、-F8N除外）固定设置10磁释放释放电流（+/-20%）固定设置1314 x Ie最大设置范围值固定设置14 x Ie最高总功率损耗Pv断路器在额定负载工作温度[W]611.5 611.6 916 33主隔离开关应用是，带附件应用条件适用于北美以外地区，（产品）组件应符合IEC 61439-1的要求，手动电机起动器适用于无粉尘、爆炸性或腐蚀性气体等危险操作条件的封闭区域。需要采用适当方式的外壳，以保护此类环境中的设备。公告电机保护断路器和电机电路保护器2-46.ab./目录首选可用目录。编号为粗体。出版物A117-CA001A-EN-P！公告电机保护断路器通用数据的规范附件，前安装的连续辅助控制块-C-AFA，右侧安装的C-AFAR辅助控制块C-ASA，-C-ASAR额定热电流Ith，环境温度40°C，环境温度60°C，符合NEMA（UL/CSA标准）端子零件端子类型螺丝刀Pozidriv 2号/刀片编号公告电机保护断路器和电机电路保护器2-47.ab./目录首选可用类别。编号为粗体。出版物A117-CA001A-EN-P！左侧安装的规范欠压跳闸-左侧安装的带2个辅助触点的C-UX欠压跳闸–左侧安装的C-UC并联跳闸-C-SN驱动电压引入压降0.851.1 x Us 0.70.35 x Us 0.851.1×Us 0.70.35 x Us 0.71.1 x Us额定控制电压最小值最大值21V 50 Hz，24V 60 Hz 600V 50 Hz 21V 50赫兹，24V 60 Hz 600V 50 Hz准时端子零件端子类型用于公告电机保护断路器的螺丝刀Pozidriv配件，连续pt母线馈线端子pt母线pt母线馈线块60°C环境温度下额定热电流Ith公告电机保护电路断路器和电机电路保护器2-48.ab./目录首选可用目录。编号为粗体。出版物A117-CA001A-EN-P！规格重量公告电机保护断路器和电机电路保护器2-49.ab./目录首选可用目录。编号为粗体。出版物A117-CA001A-EN-P！规范140-CT跳闸控制块，用于断路器上的齐平安装，欠压跳闸和并联跳闸，用于断路断路器上齐平安装额定热电流Ith高达40°C环境温度高达60°C环境电压的欠压跳闸装置，用于右侧安装在断路器上，并联跳闸用于断路器工作电压的齐平拾取线圈性能拾取引出端子端子类型细股拧紧力矩粗股拧紧力矩公告电机保护断路器和电机电路保护器2-50.ab./catalogs首选可用类别。编号为粗体。出版物A117-CA001A-EN-P！
ambient temperature ambient temperature [A] Rated Supply Current Dependence on Temperature 40 °C [A] no uction 50 °C [A] no uction no uction current uction of the upper rated current Ie Overload Protection Charteristics IEC 60947-4-1 Motor protection (except Cat. Nos. -C2N, -D8N, -F8N) IEC 60947 Ambient Temperature pensation [°C] -20 +60 Phase-loss Protection Differential release Trip class 10 (except Cat. Nos. -C2N, -D8N, -F8N) fixed setting 10 Magnetic Release Release current (+/-20 %) fixed setting 1314 x Ie max. values of setting ranges fixed setting 14 x Ie max. Total Power loss Pv Circuit Breaker at rated load operating temperature [W] 611.5 611.6 916 33 Main Disconnect Switch Application Yes, with cessories Application Conditions For utilization outside North America, assemblies (of products) shall ply to the IEC 61439-1 requirements manual motor starters are intended for use in closed areas without hazardous operating conditions such as dust or explosive or corrosive gases. Enclosures of appropriate manner need to be in ple to protect devices in such environments. Bulletin Motor Protection Circuit Breakers and Motor Circuit Protectors 2-46 .ab./catalogs Prefer availability cat. nos. are bold. Publication A117-CA001A-EN-P ! Specifications cessories for Bulletin Motor Protection Circuit Breakers General Data, Continued Auxiliary Contt Blocks for Front Mounting -C-AFA, -C-AFAR Auxiliary Contt Blocks for Right-Side Mounting -C-ASA, -C-ASAR Rated Thermal Current Ith at 40 °C ambient temperature at 60 °C ambient temperature Contt Class Coordination cording to NEMA (UL/CSA Standards) Terminal Parts Type of terminals Screwdriver Pozidriv No. 2/Blade No. Bulletin Motor Protection Circuit Breakers and Motor Circuit Protectors 2-47 .ab./catalogs Prefer availability cat. nos. are bold. Publication A117-CA001A-EN-P ! Specifications Undervoltage Trip for Left-Side Mounting -C-UX Undervoltage Trip with 2 Auxiliary Contts for Left-Side Mounting -C-UC Shunt Trip for Left-Side Mounting -C-SN tuating Voltage Pull-in Drop-out 0.851.1 x Us 0.70.35 x Us 0.851.1 x Us 0.70.35 x Us 0.71.1 x Us Rated Control Voltage min. max. 21V 50 Hz, 24V 60 Hz 600V 50 Hz 21V 50 Hz, 24V 60 Hz 600V 50 Hz 21V 50 Hz, 24V 60 Hz 600V 50 Hz On-Time Terminal Parts Type of terminals Screwdriver Pozidriv cessories for Bulletin Motor Protection Circuit Breakers, Continued pt Busbar Feeder Terminal pt Busbar pt Busbar Feeder Block Rated Thermal Current Ith at 60 °C ambient temperature Bulletin Motor Protection Circuit Breakers and Motor Circuit Protectors 2-48 .ab./catalogs Prefer availability cat. nos. are bold. Publication A117-CA001A-EN-P ! Specifications Weights Bulletin Motor Protection Circuit Breakers and Motor Circuit Protectors 2-49 .ab./catalogs Prefer availability cat. nos. are bold. Publication A117-CA001A-EN-P ! Specifications 140-CT Trip Contt Block for Flush Mounting on Circuit Breakers Undervoltage Trip and Shunt Trip for Flush Mounting on Circuit Breakers Rated Thermal Current Ith up to 40 °C ambient temperature up to 60 °C ambient temperature Undervoltage Trip Unit for Right-Side Mounting on Circuit Breakers Shunt Trip for Flush Mounting on Circuit Breakers Operating Voltage Pick-up Coil Performance Pick-up Drop-out Terminals Terminal type Fine-stranded Tightening torque Coarse-stranded Tightening torque Bulletin Motor Protection Circuit Breakers and Motor Circuit Protectors 2-50 .ab./catalogs Prefer availability cat. nos. are bold. Publication A117-CA001A-EN-P !
