MVME162-013A自动化模块备件
发射器LED：可见660 nm 1030V 35 mA取决于所选的玻璃或塑料光纤，光NPN和PNP 200 mA 1 ms 3 m电缆42SRF-6102 4针微光Powe请参见下文了解线组和附件。线组和配件描述描述描述2米（6.5英尺）4针微型线组889D-F4-2安装衬套60-2618 76（3英寸）直径反射器92--39 2米（6.5ft）4针小型线组889R-F4AEA--2直角反射器60-2052 32（1.25英寸）直径反射镜92--47光电传感器请访问我们的网站：.ab/catalogs。1--251首选可用性类别。编号以粗体打印。与小孔径传感器一起使用的玻璃纤维光缆第1-2521-257页上的玻璃纤维电缆用于小孔径传感器。接收器小孔径2.2（0.09英寸）直径发射器2.2（0.09英寸）直径。光纤控制尖端2.2（0.09英寸）直径。光纤控制尖端小孔径2.2（0.09英寸）直径。45Fxx--xxxx-xxxx-42GxF-910x小孔径传感器：42SRF-61xx 42SRF-63xx，带61-6374适配器42GTGF--101x0 42xRF--5x00FO，带61-6474适配器42GxF-910x 42KL--L2xxx 42SMF-71xx 45FVL-xxxx45FSL-xxxx注：标称传感距离•由于光纤电缆之间的差异，传感距离可能变化很大•公布的数字基于广泛的测试，并且是保守的•分叉电缆的传感距离用白皮书测量（90%反射率）。其他冲浪可能反射性较低，因此感应距离较短。•传输光束电缆的传感距离是从尖端到尖端测量的•影响距离的应用考虑因素•选择的传感器•目标的反射率•环境•附件，如测距透镜•咨询产品支持以获取更多信息。所示尺寸均为典型尺寸。小孔径传感器用玻璃光纤电缆[2.2（0.09英寸）]安装说明PHOTOSwitcher系列6000通用pt重要事项：保存这些说明以备将来使用。说明6000系列光电传感器在pt pkage中提供可靠的通用感测。Eh 6000系列传感器具有单个输出指示器。透射光束光源具有电源指示器。Eh传感器有一个离合器保护的四圈调节电位计。Eh传感器可配备3米（9.8英尺）四或五根PVC电缆，或在300（12英寸）长电缆（“尾光纤”）末端配备4针或微型快速断开接头。低压传感器具有NPN和PNP输出，输出电流为200ma。典型响应为1ms，有两个/版本可用。20-132V/传感器提供单个300mA功率MOSFET输出。20-264V/传感器提供单个150mA功率MOSFET输出。所有6000系列传感器的亮操作或暗操作由目录号选择。特点S pt圆柱形封装S广泛的传感模式选择S通用电源电压型号S NPN或PNP输出（）一般规格光源红外880nm或可见650nm单位保护反极性，假脉冲电源电压10-30V；20--132V/；20-264V/电流消耗35mA最大输出类型NPN和PNP（）；MOSFET（/）输出模式亮或暗由型号外壳材料Noryl透镜材料丙烯酸LED指示灯操作：打开（或点亮）时，传感器输出被激活；当黑暗时，它关闭。连接类型3m 300V电缆，4针微型，4针微提供的附件安装套件#129--106--1和129-106--2工作环境IP67
Emitter LED: Visible 660 nm 1030V 35 mA Depends on Glass or Plastic Fiber Optics selected Light NPN and PNP 200 mA 1 ms 3 m cable 42SRF--6102 4-pin micro Light Powe See below for cordsets and cessories. Cordsets and cessories Description Description Description 2 m (6.5 ft) 4-pin Micro Cordset 889D--F4--2 Mounting Brkets 60--2618 76 (3 in.) Diameter Reflector 92--39 2 m (6.5 ft) 4-pin Micro Cordset 889R--F4AEA--2 Right Angle Reflector 60--2052 32 (1.25 in.) Diameter Reflector 92--47 Photoelectric Sensors Visit our website: .ab./catalogs. 1--251 Prefer availability cat. nos. are printed in bold. Glass Fiber Optic Cables for use with Small Aperture Sensors The glass fiber optic cables cables on pages 1--2521--257 are for use with small aperture sensors. Receiver Small Aperture 2.2 (0.09 in.) Diameter Transmitter 2.2 (0.09 in.) Dia. Fiber Control Tips 2.2 (0.09 in.) Dia. Fiber Control Tips Small Aperture 2.2 (0.09 in.) Dia. 45Fxx--xxxx--xx 42GxF--910x Small Aperture Sensors: 42SRF--61xx 42SRF--63xx with 61--6374 adaptor 42GTGF--101x0 42xRF--5x00FO with 61--6374 adaptor 42GxF--910x 42KL--L2xxx 42SMF--71xx 45FVL--xxxx 45FSL--xxxx Note: Nominal Sensing Distance • Due to the variation between fiber optic cables, sensing distance can vary widely • The published numbers are based on extensive testing and are conservative • The sensing distance of bifurcated cables is measu with white paper (90% reflectivity). Other surfes may be less reflective and therefore would have shorter sensing distances. • The sensing distance of transmitted beam cables is measu from tip to tip • Application considerations that effect distance • Sensor selected • Reflectivity of target • Environment • cessories such as range extending lenses • Consult with product support for additional information. All dimensions indicated are typical. Glass Fiber Optic Cables Cables for Small Aperture Sensors [2.2 (0.09 in.)]Installation Instructions PHOTOSWITCHr Series 6000 General Purpose pt IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE. Description Series 6000 photoelectric sensors provide reliable general purpose sensing in a pt pkage. Eh Series 6000 sensor has a single output indicator. The Transmitted Beam Light Source has a power indicator. Eh sensor has a clutch-protected four-turn adjustment potentiometer. Eh sensor can be supplied with a 3m (9.8ft) four or five PVC cable or with a 4-pin or micro-style quick disconnect on the end of a 300 (12in) length cable (“pigtail”). Low voltage sensors have both NPN and PNP outputs with 200ma output for eh. Typical response is 1ms Two / versions are available. The 20--132V / sensor offers a single 300mA Power MOSFET output. The 20--264V / sensor offers a single 150mA Power MOSFET output. Light operate or dark operate is selected by catalog number for all Series 6000 sensors. Features S pt cylindrical pkage S Wide selection of sensing modes S Universal supply voltage models S Both NPN or PNP outputs () General Specifications Light Source Infra 880nm or visible 650nm Unit Protection Reverse Polarity, False Pulse Supply Voltage 10--30V ; 20--132V /; 20--264V / Current Consumption 35mA maximum Output Type Both NPN and PNP (); MOSFET (/) Output Mode Light or dark operate by model Housing Material Noryl Lens Material rylic LED Indicators : When on (or illuminated) the sensor output is tivated; when dark it is off. Connection Types 3m 300V cable, 4-pin micro , 4-pin micro Supplied cessories Mounting kit #129--106--1 and 129--106--2 Operating Environment IP67
