MVME162-223机械备件
危险压力敏感垫固定防护联锁门带锁第节规范控制单元符合类，响应时间垫压安全触点打开环境保护外壳端子脉冲耐受电压污染等级最小开关电流电压电源用户选择和设置也允许在±下使用功耗<继电器输出独立无电压安全触点无电压辅助触点不得用于外部安全电路保险丝，最大快速动作，最大快速作用，使用类别交流直流输出远程复位指示灯输入远程复位开关安全输入线垫指示灯电源绿色自动复位模式绿色手动复位模式绿色机器启用绿色内部控制交流电压选择器，自动手动复位选择器内部电源保险丝可更换可替换可换个个关闭个关闭可重置个工作温度范围至湿度在时敢达根据进行振动测试，频率范围位移每轴扫描频率个周期，每分钟倍频程接触器监控回路常闭接触器回路最大导线尺寸为绞合绞合，套管剥离，套管剥离实心导体实心导体端子减去端子减去端子固定螺钉螺钉端子螺钉，安装，自举至至连接垫圈端子板，可单独拆卸安装组，符合材料聚碳酸酯钢聚碳酸酯聚碳酸酯屏幕固定细节孔孔导轨其他。在手动复位模式下，必须连接复位按钮外壳路导轨重量传感器垫传感器垫符合，类别，有保证检测的人的最小重量最大检测区域单个垫的最大数量无限制最多连接线的最大总长度质量传感器垫环境保护垫机械寿命操作湿度传感器垫外层材料乙烯基标准颜色黄色操作温度范围至存储温度范围至由互连传感器垫和控制单元组成的系统符合第类的要求。控制单元电源或可选继电器输出独立无电压安全触点独立无压监控触点无电压辅助触点无电压无辅助触点安全输入带模制连接器的线垫指示灯电源绿色手动复位模式绿色自动复位模式绿色机器启用绿色信道故障状态绿色端子减去安装在处的端子螺钉注所有其他规格和尺寸详情请参阅控制单元。图显示检测区的周边修剪和联合修剪详图。有关机器接口的指导，请参阅第节。有关固定和互连安排的详细信息，请参阅节。
Dangerous pressure sensitive pad fixed protection interlock door with lock Section Specification Control unit compliance, response time pad pressure safety contact open environmental protection enclosure terminal impulse withstand voltage pollution level minimum switching current voltage power supply user selection and setting also allows the use of power consumption under ±<relay output independent voltage free safety contact voltage free auxiliary contact shall not be used for external safety circuit fuse, maximum quick action, maximum quick action, Use category AC and DC output remote reset indicator input remote reset switch safety input line pad indicator power green automatic reset mode green manual reset mode green machine enable green internal control AC voltage selector, automatic manual reset selector internal power fuse can be replaced can be replaced can be replaced can be closed can be reset operating temperature range to humidity can be reached when vibration test is conducted according to, The frequency range displacement scans frequency cycles per axis, and the maximum conductor size of the normally closed contactor circuit of the octave range contactor monitoring circuit per minute is stranded, the casing is stripped, the casing is stripped, the solid conductor terminal subtracts the terminal subtracts the terminal fixing screws, the terminal screws, the installation, and the installation can be lifted to the connecting gasket terminal board, and the installation group can be disassembled separately, Comply with material polycarbonate steel polycarbonate polycarbonate screen fixing details hole guide others. In the manual reset mode, the reset button must be connected to the housing, the guide rail, the weight sensor pad, and the sensor pad, The minimum weight of the person to be tested, the maximum number of single pads in the maximum detection area, unlimited, the maximum total length of the connecting line, the mass sensor pad, the environmental protection pad, the mechanical life, the operating humidity sensor pad, the outer layer material, the vinyl standard color, the yellow, the operating temperature range, the storage temperature range, and the system composed of interconnected sensor pads and control units meet the requirements of Category. Control unit power supply or optional relay output independent voltage free safety contact independent voltage free monitoring contact voltage free auxiliary contact voltage free auxiliary contact safety input wire pad indicator with molded connector power green manual reset mode green automatic reset mode green machine start green channel fault state green terminal minus terminal screws installed at Note For all other specifications and size details, please refer to the control unit. Figure shows the details of peripheral trim and joint trim of the detection area. Refer to section for instructions on machine interfaces. For more information on fixing and interconnection arrangements, see section.
