MVME162PA-242工控备件模块
适合检测手指控制单元不得安装在危险区内。手动复位或常规指示器观察需要接近控制单元，因此必须能够看到其运行。只要唯一的危险是实际的门，控制单元可以安装在电动门的任何一侧。在所有其他情况下，考虑到测试和维护的访问要求，控制单元可以安装在危险区外任何方便的地方。安装表面安装导轨安装导轨安装+固定孔重置端子不同的功能表面安装提供的跳线导轨不提供跳线。在没有跳线的情况下，端子可以连接到机器接触器上的正向引导常闭辅助触点，以监控双通道控制系统中的接触器。如果一个接触器在其控制线圈断电时未能隔离电源，则系统将不允许另一个接触器通电，直到故障得到纠正。如果不需要此功能，请在导轨装置的这些端子之间安装跳线。此端子也用于自动手动复位。如果端子未跨接或仅连接至接触器常闭触点，则装置处于自动复位模式。在自动复位模式下，仅通过移除驱动力来实现输出。在致动器通电时当不存在驱动力时也可以实现输出。如果根据的风险评估结果，自动重启可能会产生风险，则不得使用该模式。参见和对于手动复位模式，常开弹簧复位非闭锁按钮必须跨端子连接，或与常闭接触器串联。当移除驱动力时，只有按下按钮，装置才会运行。
The control unit suitable for detecting fingers shall not be installed in the hazardous area. Manual reset or conventional indicator observation requires access to the control unit, so it must be possible to see its operation. As long as the only danger is the actual door, the control unit can be installed on either side of the electric door. In all other cases, considering the access requirements for testing and maintenance, the control unit can be installed at any convenient place outside the hazardous area. Mounting surface mounting rail Mounting rail mounting+fixing hole resetting terminal Different functions The jumper rail provided by surface mounting does not provide jumpers. Without jumpers, the terminals can be connected to the positive pilot normally closed auxiliary contacts on the machine contactors to monitor the contactors in the dual channel control system. If a contactor fails to isolate power when its control coil is de energized, the system will not allow another contactor to be energized until the fault is corrected. If this function is not required, install jumpers between these terminals of the rail unit. This terminal is also used for automatic and manual reset. If the terminals are not jumpered or only connected to the normally closed contacts of the contactor, the device is in automatic reset mode. In the automatic reset mode, the output is achieved only by removing the driving force. The output can also be achieved when there is no driving force when the actuator is energized. This mode should not be used if, based on the results of the risk assessment, automatic restart may create risks. See and for manual reset mode, the normally open spring reset non locking button must be connected across terminals or in series with the normally closed contactor. When the driving force is removed, the device will not operate until the button is pressed.
