MVME162PA-242LSE备件库存
不属于自动化的商标是其各自公司的财产。年月版权所有© .保留所有权利。美国印刷。取代 年月产品规格目录编号描述 功率表指示器 电量表 交流 脉冲数字输出 电源表交流 交流交流模拟输出 功率计 串行功率计 氰基丙烯酸酯粘合剂确保持久密封和高防护等级达到。.安装轨道轨电缆连接器，将盖子封闭到控制单元或下一个带电阻器的型材连接器 维修在系统或机器控制系统上工作前，将电源与机器和系统隔离。遵守电气安全预防措施。用户维修仅限于更换新的系统部件。如果出现任何问题，应将装置退还给供应商。应使用热缩对接接头对连接线进行任何维修。更换任何零件后，必须对更换的零件进行和所示的检查和测试，并特别注意。篡改零部件将使保修失效。如果导轨控制单元上的质量密封损坏，则保修无效警告维护或维修操作后，必须正确重新安装所有紧固电缆保护装置。未能做到这一点或使用未经批准的部件可能会导致系统无法达到其规定的性能。安装型导轨.安全型材的组装和安装将安全型材切割成一定长度。无滑行室的型材应使用橡胶剪进行切割。带有滑行室的型材应使用细齿锯切割。安装时钻孔未提供紧固件 型材清洁型材应保持无沉积物，如切屑和其他材料，以防止损坏或死区。
Trademarks that are not automatic are the property of their respective companies. Copyright © . All rights reserved. Printed in the USA. Replace the product specification catalog number of the month and year Description of power meter Indicator of power meter AC pulse digital output power meter AC AC analog output power meter Serial power meter Cyanoacrylate adhesive ensures durable sealing and high protection level Install the rail cable connector, close the cover to the control unit or the next profile connector with resistor, and isolate the power supply from the machine and the system before working on the system or machine control system. Observe electrical safety precautions. User maintenance is limited to replacing new system components. In case of any problems, the unit shall be returned to the supplier. Any repairs to the connecting wires shall be made using heat shrinkable butt joints. After any parts are replaced, the replaced parts must be inspected and tested as shown in and with special attention. Tampering parts will void the warranty. If the quality seal on the rail control unit is damaged, the warranty is invalid WarningAfter maintenance or repair operations, all fastening cable protectors must be reinstalled correctly. Failure to do so or the use of unapproved components may cause the system to fail to achieve its specified performance. Mounting type guide rail The assembly and installation of the safety profile cut the safety profile into a certain length. The profile without sliding chamber shall be cut with rubber shear. Sections with sliding chambers shall be cut with a fine tooth saw. When installing, the drilling does not provide fasteners. The cleaning profile should be kept free of sediment, such as chips and other materials, to prevent damage or dead zones.
