MVME162PA-242SE机械设备卡件
交流脉冲数字输出 功率计 交流电脉冲数字输出输出功率监视器串行功率表 交流脉冲 功率计 模拟输出 串行功率计 交流模拟输出 功率计指示灯 和 电量计 脉冲数字输出 功率计 和 模拟输出 功率计交流和 串行功率计交流电和 交流电当Ω 如果存在电阻即正常运行条件，则向机器控制电路产生信号。如上图所示，当型材从任何方向按时，顶部导电橡胶条压缩并接触中间导电橡胶，从而产生“短路”，整体电阻下降。这由启动机器停机的控制单元监控。将检测配置文件中的任何单个故障或配置文件的接线连接，控制单元输出将进入安全状态。单个型材通过导线轴向连接器或标准连接器相互连接。配置文件通过两根导线连接到控制单元。控制单元具有完全交叉监控的安全继电器，可以配置该单元，以便检测到外部接触器故障。控制单元电气故障符合 第类和 的要求，机器控制系统的相关部分也能满足这些要求。型材符合 第类的要求。系统符合欧洲指令的要求。在工业环境中可能出现的干扰条件下，由于其已经过测试和认证，因此可以确保正常运行。注：在存在异常高水平的情况下，可能需要采取特殊措施，例如靠近焊接或感应加热设备或靠近无线电发射机收发器。导电橡胶非导电橡胶软电线芯软铜线芯将信号发送给评估人员“接触”区域 常规检查和测试记录见第节和节日期检查意见.安全系统的安装仅使用氰基丙烯酸酯。
AC pulse digital output power meter AC pulse digital output power monitor Serial power meter AC pulse power meter Analog output serial power meter AC analog output power meter Indicator light and coulometer Pulse digital output power meter and analog output power meter AC and serial power meter AC and AC current and AC current If there is resistance that is normal operating conditions, it will generate signals to the machine control circuit. As shown in the above figure, when the profile is in any direction, the top conductive rubber strip compresses and contacts the middle conductive rubber, resulting in a "short circuit" and the overall resistance decreases. This is monitored by the control unit that initiates the machine shutdown. Any single fault in the configuration file or the wiring connection of the configuration file will be detected, and the control unit output will enter the safe state. Individual profiles are connected to each other by wire axial connectors or standard connectors. The configuration file is connected to the control unit by two wires. The control unit has a fully cross monitored safety relay, which can be configured to detect external contactor faults. The electrical faults of the control unit meet the requirements of and, and the relevant parts of the machine control system can also meet these requirements. The profiles meet the requirements of category. The system complies with the requirements of European directives. Under the interference conditions that may occur in the industrial environment, normal operation can be ensured because it has been tested and certified. Note: In the case of abnormally high levels, special measures may be required, such as proximity to welding or induction heating equipment or proximity to radio transmitter transceivers. Conductive rubber non-conductive rubber flexible wire core flexible copper wire core sends signals to the evaluator. See section and section date inspection comments for routine inspection and test records of the "contact" area. Only cyanoacrylate is used for the installation of the safety system.
