MVME167-34B模块备件
1.2V DC下的电流消耗-5.1V DC时的电流消耗1200 mA 24V DC时的电压消耗14 mA功耗3.5 W散热11.9 BTUhr隔离电压30V（连续），基本绝缘类型，RS-232至系统类型，在720V DC下测试60 s串行电缆1756-CP3或1747-CP3，控制器的直角连接器，直接到串行端口3米（9.84英尺）重约0.32千克（0.70磅）插槽宽度2，（两个模块都需要；每个都是一个插槽）模块位置机箱底座任何插槽（安全伙伴必须安装在主控制器右侧的插槽中）机箱1756-A4、1756-A7、1756-A10、1756-A13、1756-A17电源标准1756-PA72、1756-PA75、1756-PB72、，1756-PB75导线类别使用此导线类别信息规划导线布线，如系统级安装手册所述。参见工业自动化布线和接地指南出版物1770-4.1.2-RS-232端口北美温度代码T4A外壳类型额定值无（开放式）罗克韦尔自动化出版物1756-TD001G-EN-P-2013年1月17 1756 ControlLogix控制器表19-环境规范-1756-L6xS GuardLogix控制器属性1756-L61 1756-L62 1756-L63 1756-LSP温度，1756-L61 1756-L62 1756-L63 1756-LSP上的运行IEC 60068-2-1（试验A运行低温）、IEC 60068-2-2（试验B运行干热）、IEC 6008-2-14（试验N运行热冲击）0…60°C（32…140°F，IEC 60068-2-14（试验N无包装非工作热冲击）-40…85°C（-40…185°F）环境空气温度，最高60°C（140°F）相对湿度IEC 60068-2-30（试验D未包装湿热）5…95%非冷凝振动IEC 60068-2-6（试验F运行）2 g@10…500 Hz Shoc运行IEC 60068-2-27（试验E未包装冲击）30 g Shoc未运行IEC 60068－227（试验E不包装冲击）50 g排放CISPR 11 IEC 61000-6-4 A级ESD抗扰度IEC 61000-4-2 6 kV接触放电8 kV空气放电辐射射频抗扰度IEC 61000-4-3 10Vm，1 kHz正弦波，80%AM，从80…2000 MHz 10Vm，200 Hz 50%脉冲，100%AM@900 MHz 10Vm和200 Hz 50%，100%AM，1890 MHz 3Vm，1 Hz正弦波，80%AM，从2000…2700 MHz EFTB抗扰度，IEC 61000-4-4±4 kV，5 kHz，RS-232端口浪涌瞬态抗扰度IEC 61000-4-6 10V rms，1 kHz正弦波80%AM，150 kHz…80 MHz 18罗克韦尔自动化出版物1756-TD001G-EN-P-2013年1月1756 ControlLogix控制器表20-认证-1756-L6xS GuardLogix控制器认证标记时。有关符合性声明、证书和其他认证详细信息，请参见产品认证链接：www.ab.com。1756-L61 1756-L62 1756-L63 1756-LSP c-UL-us UL认证工业控制设备，适用于美国和加拿大。参见UL文件E65584。UL列出了经美国和加拿大认证的2类D组危险场所。参见UL文件E194810。CSA CSA认证过程控制设备。参见CSA文件LR54689C。CSA认证的过程控制设备，适用于2类D组危险场所。参见CSA文件LR69960C。CE欧盟2004108EC EMC指令，符合：EN 61000-6-4；工业排放EN 61326-1；测量控制实验室。，工业要求EN 61000-6-2；工业抗扰度EN 61131-2；可编程控制器（第8条，A区和B区）欧盟200642EC M符合：EN 60204-1；机器电气设备EN ISO 13849-1；控制系统的安全相关部件EN 62061；安全相关控制系统的功能安全C-Tick澳大利亚无线电通信Ac符合：AS/NZS CISPR 11；工业排放FM FM认证设备，用于第2类D组危险场所KC韩国广播和通信设备注册，符合：无线电波交流条款第58-2条
Current draw @ 1.2V DC — Current draw @ 5.1V DC 1200 mA Current draw @ 24V DC 14 mA Power dissipation 3.5 W Thermal dissipation 11.9 BTUhr Isolation voltage 30V (continuous), Basic Insulation Type, RS-232 to system Type tested at 720V DC for 60 s Serial cables 1756-CP3 or 1747-CP3, right angle connector to controller, straight to serial por 3 m (9.84 ft) Weigh approx 0.32 kg (0.70 lb) Slot width 2, (both modules needed; each is one slot) Module location Chassis-base any slot (the safety partner must be installed in the slot to the immediate right of the primary controller) Chassis 1756-A4, 1756-A7, 1756-A10, 1756-A13, 1756-A17 Power supply standard 1756-PA72, 1756-PA75, 1756-PB72, 1756-PB75 Wire category Use this conductor category information for planning conductor routing as described in the system level installation manual. See the Industrial Automation Wiring and Grounding Guideline publication 1770-4.1. 2 - on RS-232 port North American temperature code T4A Enclosure type rating None (open-style) Rockwell Automation Publication 1756-TD001G-EN-P - January 2013 17 1756 ControlLogix Controllers Table 19 - Environmental Specifications - 1756-L6xS GuardLogix Controllers Attribute 1756-L61 1756-L62 1756-L63 1756-LSP Temperature, operating IEC 60068-2-1 (Test A Operating Cold), IEC 60068-2-2 (Test B Operating Dry Heat), IEC 60068-2-14 (Test N Operating Thermal Shock) 0…60 °C (32…140 °F) on 1756-L61 1756-L62 1756-L63 1756-LSP Temperature, storage IEC 60068-2-1 (Test A Unpackaged Nonoperating Cold), IEC 60068-2-2 (Test B Unpackaged Nonoperating Dry Heat), IEC 60068-2-14 (Test N Unpackaged Nonoperating Thermal Shock) -40…85 °C (-40…185 °F) Temperature, surrounding air, max 60 °C (140 °F) Relative humidity IEC 60068-2-30 (Test D Unpackaged Damp Heat) 5…95% noncondensing Vibration IEC 60068-2-6 (Test F Operating) 2 g @ 10…500 Hz Shoc operating IEC 60068-2-27 (Test E Unpackaged Shock) 30 g Shoc nonoperating IEC 60068-2-27 (Test E Unpackaged Shock) 50 g Emissions CISPR 11 IEC 61000-6-4 Class A ESD immunity IEC 61000-4-2 6 kV contact discharges 8 kV air discharges Radiated RF immunity IEC 61000-4-3 10Vm with 1 kHz sine-wave 80% AM from 80…2000 MHz 10Vm with 200 Hz 50% Pulse 100% AM @ 900 MHz 10Vm with 200 Hz 50% Pulse 100% AM @ 1890 MHz 3Vm with 1 kHz sine-wave 80% AM from 2000…2700 MHz EFTB immunity IEC 61000-4-4 ±4 kV at 5 kHz on RS-232 port Surge transient immunity IEC 61000-4-5 ±2 kV line-earth (CM) on RS-232 port Conducted RF immunity IEC 61000-4-6 10V rms with 1 kHz sine-wave 80% AM from 150 kHz…80 MHz 18 Rockwell Automation Publication 1756-TD001G-EN-P - January 2013 1756 ControlLogix Controllers Table 20 - Certifications - 1756-L6xS GuardLogix Controllers Certification When marked. See the Product Certification link at http:www.ab.com for Declarations of Conformity, Certificate and other certification details. 1756-L61 1756-L62 1756-L63 1756-LSP c-UL-us UL Listed Industrial Control Equipmen certified for US and Canada. See UL File E65584. UL Listed for Class Division 2 Group D Hazardous Location certified for U.S. and Canada. See UL File E194810. CSA CSA Certified Process Control Equipment. See CSA File LR54689C. CSA Certified Process Control Equipment for Class Division 2 Group D Hazardous Locations. See CSA File LR69960C. CE European Union 2004108EC EMC Directive, compliant with: EN 61000-6-4; Industrial Emissions EN 61326-1; Meas.ControlLab., Industrial Requirements EN 61000-6-2; Industrial Immunity EN 61131-2; Programmable Controllers (Clause 8, Zone A & B) European Union 200642EC M compliant with: EN 60204-1; Electrical equipment of machines EN ISO 13849-1; Safety-related parts of control systems EN 62061; Functional safety of safety-related control systems C-Tick Australian Radio communications Ac compliant with: ASNZS CISPR 11; Industrial Emissions FM FM Approved Equipment for use in Class Division 2 Group D Hazardous Locations KC Korean Registration of Broadcasting and Communication Equipmen compliant with: Article 58-2 of Radio Waves Ac Clause
