PFSK160A 3BSE009514R1工业自动化卡件
隔离机器和垫子系统的电源。遵守电气安全预防措施。用户维修仅限于更换新的垫系统部件。如果出现问题，应将装置退还给供应商。应使用推荐的对接拼接接头对连接线进行任何维修。篡改零部件将使保修失效。如果DIN导轨控制单元上的质量封条损坏，则保修无效。39可用备件对于特殊尺寸的传感器垫，请参阅标签上打印的型号。更换任何零件后，必须进行8.2所示的检查和测试，并特别注意更换的零件。警告：维护或维修操作后，必须正确重新安装所有镶边、紧固件和电缆保护装置。不这样做或使用未经批准的零件或修改可能导致垫子系统无法达到其规定性能。8.7服务如需服务和协助，请联系供应商。尺寸型号。周边装饰指定长度MGT 3010两件式周边装饰指定MGT 3011长度（带电缆干线）单元装饰指定长度MG T 3020保护电线导管指定长度MGG 3030 Mat控制单元MGCP1 MGCS1 MGCD1 MGCSM1与MGCD1系统备件套件描述零件号2保险丝500mA（T）TR5 4对接拼接连接器108433 4引脚卷曲1推压按钮灯泡标准尺寸型号。传感器垫500mm x 500mm米高梅1010传感器垫750mm x 500mm米高梅1510传感器垫1000mm x 500mm米高梅2010传感器垫500mm×1500mm米高梅1030传感器垫750毫米x 750mm米高梅1515传感器垫1000mm×750mm米高梅2015传感器垫750毫米x 1500mm米高梅1530传感器垫1000毫米x 1000mm米高梅2020传感器垫1000 mm x 1250mm米高米2025传感器垫1000 x 1500mm米米高梅2030 40长度目录号。标准周边饰件2M 440F-T3210标准周边饰件3M 440F-T3310标准周边内饰5M 440F-T3510外角标准周边饰件-440F-T3012内角标准周边内饰-440F-T301带电缆通道的周边饰件2M440F-T3211带电缆通道4M 440F-T3411带电缆槽的外角周边饰件-440 F-T3014内角带电缆槽的周边装饰件-440F-T3015 Activ YNN 440F-T2030 41日期：检查人：评论常规检查和测试记录（见第8.2节）建议每周进行一次。全面检查和测试记录（见第8.3节）-建议每月6次。日期：审查人：评论日期：检查人：评论42图纸编号：28563/2更改编号：26190 RField Switching and Sensing>Non Contact Sensor>光电传感器>Allen-Bradley光电传感器>反光传感器>紧凑型矩形RETRO 11-30VDC RED 25mm-5M PNP/NPN DC-MICRO-4目录编号：42KL-U2LB-F4·光电传感技术的全面范围可提供包括回射、穿透光束、漫射、背景抑制、清晰物体检测、颜色检测和光纤·可提供适用于高精度应用的广泛的带激光光源的光电传感器·广泛的外壳样式和安装选项·专业版本
isolate power source to the machine and mat system. Observe electrical safety precautions. User repairs are limited to replacement by new mat system parts. In the event of problems, the units should be returned to the supplier. Any repairs to the connecting wires should be made using the recommended butt splice connectors. TAMPERING WITH COMPONENT PARTS WILL INVALIDATE WARRANTY. WARRANTY INVALID IF QUALITY SEAL IS BROKEN ON DIN RAIL CONTROL UNIT. 39 AVAILABLE SPARES For special sized sensor mats, refer to the model no. printed on the label. After replacing any parts the inspection and test shown at 8.2 must be carried out with special attention given to those parts replaced. WARNING After maintenance or repair operations it is important that all edging trims, fastenings and cable protection are correctly refitted. Failure to do this or the use of non approved parts or modifications may result in the mat system failing to achieve its specified performance. 8.7 SERVICE For service and assistance please contact the supplier. Size Model No. Perimeter trim Specify length MGT 3010 Twp piece perimeter trim Specify length MGT 3011 (with cable trunk) Uniting trim Specify length MGT 3020 Protective wire guide Specify length MGT 3030 Mat Control unit MGCP1 MGCS1 MGCD1 MGCSM1 Remote indication unit for use with MGCD1 MGRID1 System Spares Kit Description Part No. 2 Fuses 500mA(T) TR5 4 Butt splice connectors 108433 4 Pin crimps 1 Push button bulb Standard sIzes Model No. Sensor mat 500mm x 500mm MGM 1010 Sensor mat 750mm x 500mm MGM 1510 Sensor mat 1000mm x 500mm MGM 2010 Sensor mat 500mm x 1500mm MGM 1030 Sensor mat 750mm x 750mm MGM 1515 Sensor mat 1000mm x 750mm MGM 2015 Sensor mat 750mm x 1500mm MGM 1530 Sensor mat 1000mm x 1000mm MGM 2020 Sensor mat 1000mm x 1250mm MGM 2025 Sensor mat 1000mm x 1500mm MGM 2030 40 length Catalog No. Standard Perimeter Trim 2M 440F-T3210 Standard Perimeter Trim 3M 440F-T3310 Standard Perimeter Trim 5M 440F-T3510 External Corner Standard Perimeter Trim - 440F-T3012 Internal Corner Standard Perimeter Trim - 440F-T3013 Perimeter Trim with Cable Channel 2M 440F-T3211 Perimeter Trim with Cable Channel 4M 440F-T3411 External Corner Perimeter Trim with Cable Channel - 440F-T3014 Internal Corner Perimeter Trim with Cable Channel - 440F-T3015 Activ YNN 440F-T2030 41 Date: Inspected by: Comments Record of ROUTINE INSPECTION AND TEST (see Section 8.2) Recommended weekly. Record of THOROUGH EXAMINATION AND TEST (see Section 8.3) - Recommended 6 monthly. Date: Examined by: Comments Date: Inspected by: Comments 42 Drawing No: 28563/2 Change No: 26190 RField Switching and Sensing > Non Contact Sensors > Photoelectric Sensors > Allen-Bradley Photoelectric Sensors > Retroreflective Sensors > Compact Rectangular RETRO 11-30VDC RED 25mm-5M PNP/NPN DC-MICRO-4 Catalogue No: 42KL-U2LB-F4 · Comprehensive range of photoelectric sensing technologies available which include retroreflective, through-beam, diffuse, background suppression, clear object detection, colour detection and fibre-optics · Extensive range of photoelectric sensors with laser light source available suitable for high precisions applications · Extensive range of housing styles and mounting options · Specialised versions
