PPC902AE101 3BHE010751R0101模块备件
W固定相关单元的盖子。断开机器原动机与最终接触器的连接，使机器无法移动。6.3检查机械安装1.检查传感器垫、周边装饰件和联合装饰件是否完好无损，是否正确定位和固定。检查是否达到了设计的安全距离。2.检查除了通过垫子之外，是否无法进入危险区域，并且任何固定防护装置等是否根据设计进行了定位，并且是否安全。3.检查危险区和垫子系统之间是否有人。4.检查当前或可预见的环境条件是否符合设计阶段考虑的环境条件。5.检查安装是否无设计阶段未预见到的危险。6.检查所有警告通知是否到位。7.检查是否已安装所需的任何其他保护措施。6.4检查电气功能1.确保垫子上没有人员和设备。暂时断开机器控制系统提供的任何自动复位功能。恢复机器电源，但确保机器原动机仍与机器最终接触器断开。A、 仅手动模式（使用440F-C28013控制单元时不相关）2.检查控制单元：-绿色LED-电源亮起-绿色LED–手动复位亮起-复位按钮中的复位灯亮起-红色LED-机器启用关闭。3。按下并松开重置按钮-检查机器启用LED亮起，重置灯熄灭-站在垫子上，检查机器启用指示灯熄灭。
WSecure lid on relevant units. DISCONNECT THE MACHINE PRIME MOVER FROM THE FINAL CONTACTOR(S), SO THAT NO MACHINE MOVEMENT CAN TAKE PLACE. 6.3 CHECKING THE MECHANICAL INSTALLATION 1. Check that sensor mats, perimeter trim and uniting trims are undamaged and correctly positioned and secured. Check that the designed safety distance has been achieved. 2. Check that access to the hazard zone is not possible other than via the mat and that any fixed guards etc. are positioned according to the design and are secure. 3. Check that the presence of a person between the hazard zone and mat system is prevented. 4. Check that the environmental conditions present or foreseeable correspond to those considered during the design stage. 5. Check that the installation is free of hazards not foreseen at the design stage. 6. Check that any warning notices are in place. 7. Check that any other protective measures required have been installed. 6.4 CHECKING THE ELECTRICAL FUNCTIONS 1. Ensure the mat is clear of persons and equipment. Temporarily disconnect any automatic reset function provided by the machine control system. Reinstate the machine power supply but ensure that the machine prime mover is still disconnected from the machine final contactor(s). A. MANUAL MODE ONLY (not relevant when using 440F-C28013 control unit) 2. Check on the Control unit that: - the green LED - POWER is illuminated - the green LED - MANUAL RESET is illuminated - the reset lamp in the reset button is illuminated - the green LED - MACHINE ENABLED is off. 3. Press and release the reset button - check the MACHINE ENABLED LED comes on and the reset lamp goes off - stand on the mat and check the MACHINE ENABLED LED goes off.
