PPD113-B03-10-150000工控模块备件
选择电源系统提供四种电源选择，在任何情况下，机器都会提供合适的电源。检查电源参数是否符合规范中给出的垫系统要求。如果使用24V AC或DC电源，则必须根据国际电气安全惯例（IEC 364-4-41）将其与主电源隔离。一个极应接地（直流电源负极接地）。如果必须作出特殊安排，则可随时提供适合系统的24V DC商用装置。辅助输出这是作为状态输出提供的非安全输出。它在使用PLC功能机器控制和硬接线安全电路作为PLC状态输入的系统中特别有用。其他用途包括保护方案中的诊断和/或驱动状态灯或警报。安全功能不得依赖于此输出。电弧抑制建议所有感应负载使用电弧抑制网络或设备。对于安全电路，抑制器应安装在负载上，而不能安装在触点上。抑制器的类型和额定值将由电源和负载特性决定。注意，抑制器可以增加响应时间，特别是直流线圈两端的抑制器二极管，并且在测量响应时间时应安装到位。控制单元安全输出电源至控制单元执行力时间20ms响应时间控制单元安全输入电源至控制装置重置执行力时间20m s响应时间24接触器监控接触器监控通过标记为MC的两个端子提供。
The optional power supply system provides four power supply options. In any case, the machine will provide appropriate power supply. Check whether the power supply parameters meet the requirements of the cushion system given in the specification. If 24V AC or DC power supply is used, it must be isolated from the main power supply according to international electrical safety practices (IEC 364-4-41). One pole should be grounded (the negative pole of DC power supply is grounded). If special arrangements must be made, 24V DC commercial devices suitable for the system can be provided at any time. Auxiliary Output This is a non safe output provided as a status output. It is particularly useful in systems that use PLC function machine control and hardwired safety circuits as PLC status inputs. Other uses include diagnostics and/or driving status lights or alarms in the protection scheme. The safety function must not depend on this output. Arc suppression It is recommended that all inductive loads use an arc suppression network or device. For safety circuits, suppressors shall be mounted on the load, not on the contacts. The type and rating of suppressors will be determined by the power supply and load characteristics. Note that the suppressor can increase the response time, especially the suppressor diodes at both ends of the DC coil, and should be installed in place when measuring the response time. The time from the safe output power of the control unit to the execution force of the control unit is 20ms, and the response time is 20ms. The time from the safe input power of the control unit to the reset execution force of the control device is 20ms. The response time is 24. The contactor monitoring is provided through two terminals marked MC.
